I have a LeClerc rigid heddle loom (single heddle).  I have 2 heddle options - 6 DPI or 12 DPI.  I'd like to use a wool that I would normally set at 9 EPI on my floor loom.  So here's the question.

Is either of the options below possible to produce a reasonable product?  Is one of option better than the other?

Thread the 12 DPI, leaving every 5th dent (slot or hole) empty, resulting in 10 DPI.  I'm thinking that this would all even out in the wet finishing.  (If this is the better option, does it matter if I leave a slot or a hole empty?) 

OR

Thread the 6 DPI, with 2 threads in every other slot, resulting in 8 DPI.  (I do realize this will have an impact on my woven pattern.  That's okay with me.)

I know, I know, I should sample.  And if no one here has information, I will.  But this groups hasn't failed me yet!

Comments

Claudia Segal (not verified)

I would sample no matter which option you choose.

I have woven several scarves using a 12 dpi and threading it with one and two slots and corresponding holes left blank.  It does not show on the finished piece either on or off the loom.  If your goal is 8 epi, I would go with the 12 dpi and leave the first and last set of slot/hole empty for every inch threaded.

Hope that helps.  i wove this scarf with that exact configuration.

Claudia

peg.cherre (not verified)

Gee, when I pulled out the yarn, it was much finer than a worsted.  12 DPI will be just fine.

Should have looked first, instead of relying on my memory.

Thanks for the input, Claudia!

Submitted by Anonymous (not verified) on