Here's my homemade spool stand. Found the pigtail screws at LeClerc. They are ceramic coated for smooth sliding of thread or yarn. Holds 16 spools. Don't think I need the 40 spool holder like the Leclerc stand. Also have space for 5 large cones on the base.Total cost about $55 . Still need to do some sanding and then shellac it. Also made my own 1"sectional beam pieces to go on my warp beam for $108,(See in photo to left of spool stand on the floor). Bought the U staples from GlimakraUSA. I enjoy making my own accessories. Modifying to my needs. A lot cheaper too. I guess being into woodworking for 25+years and having all the woodworking tools they make, I have an advantage over most people when it comes to making loom parts and tools..............Steve.

Comments

Dawn McCarthy

Your work looks great!  I too like to construct some of my own tools - they are often not pretty but work well - I have made a winding station (large) a large warping mill, a drawloom attachment for a loom, a sectional warp beam for an avl.  My question is?  Did you purchase the rails with the 1 inch spacing and then add to a beam or build the whole thing?  If so - may I ask where you got your hoops?

 

Dawn

 

Bloominloom.wordpress.com

steve104c (not verified)

Dawn, Leclerc has them for $1.00 ea., but Joanne @ Glimakra has them for $.60 ea. So where do you think I bought mine? I had a piece of 1 1/2" thick of oak for the wood pieces. The drill bit size was a 25 wire. Not the normal " sizes. You realy need a drill press to get right spacing. To get the correct number of staples, measure your warp beam. Multiply the inches by 4, the number of sectional pieces...................Steve.
Submitted by Anonymous (not verified) on