I would appreciate some help in finishing the tying up of a Lillistina 4 shaft loom. The current setup is as follows:
The Shaft Horses (Rockers) are tied up:
Left Side Front rocker. Outside to Shaft 1 - Inside to Shaft 2
Right Side Front Rocker. Outside to Shaft 1 - Inside to Shaft 2
Left Side Rear Rocker. Outside to Shaft 3 - Inside to Shaft 4
Right Side Rear Rocker Outside to Shaft 3 Inside to Shaft 4
The Lams are connected to the treadles as follows, numbering from front to back on the Lams and left to right on the treadles.
Lam 1 to treadles 2,4, and 5
Lam 2 to treadles 1,5 and 6
Lam 3 to treadles 2,3 and 6
Lam 4 to treadles 1,3 and 4
With the above tie up. How should I connect the Shafts to the Lams? Is it simply Shaft 1 to Lam 1, Shaft 2 Lam 2 etc.
Comments