I really thought it would take longer than this, but now I'm really frustrated.  On my Schacht 4-shaft floor loom, I've done a project of five towels (should have been four, but ended up with five) and now I'm working on a color gamp.  With the towels, I struggled through the left floating selvage breaking numerous times (literally too many to count) and now, I can't even get 1/2 inch in before the floating selvage breaks.  I've removed all the loose heddles on that side, thinking that maybe they were rubbing against the yarn . . . but it made no difference.  Any ideas?

Thanks so much in advance,

Mary Kaye

Comments

lkautio (not verified)

Hi Mary Kaye,  These problems can be frustrating but are usually easy to solve.

If it is just the floating selvage, perhaps you can rearrange the last few threads so that you don't need a floating selvage. 

Sometimes just changing the side you start throwing the shuttle from will do the trick. 

Check that the tension is equal on the two sides of the warp and that the floater is the same tension. 

Try replacing the floater with a stronger thread of the same color and fiber (5/2 or two strands of 10/2 instead of one strand of 10/2) and weighting it separately.

If that's not it, check your draw-in.  Usually when this happens the weavers draws in more on the side that is breaking. 

Sometimes it is the yarn.  One cone was old or damaged, or different colors are more fragile (black and red are more common culprits). 

Occasionally the loom is out of square or not completely unfolded on one side.

Good luck! 

Laurie Autio

Joanne Hall

Hi Mary Kaye,

Are you using a temple?  The breaking of a selvage thread is usually caused by the towel being narrower than the warp width in the reed.  And it can be a problem on one selvage more than another because we are usually right handed or left handed.  We usually can throw better or faster than one hand than another.  Watch how you handle the shuttle to see if there is a difference.  Throwing faster eliminates the weft loom at the selvage.  If you need to pull on the weft to eliminate that little loop, that might be the problem. 

But the temple will solve the broken weft problem.  It will also make the beating easier, give you more wefts per inch and make the weaving go faster without having to stop to fix broken threads.

You can read about temples in my weaving FAQ.

 http://glimakrausa.com/faq.html

Click on selvages, temples

Joanne

zinniz (not verified)

I agree with Joanne that a temple might help you out.  I have many fewer broken selvedge ends when I use one.  Here's a site that has instructions for a simple temple that really works.  http://www.woolgatherers.com/id105.htm 

fiberfan (not verified)

Is the left selvage thread untwisting?  I used floating selvages on some 2/1 twill scarves a couple of months ago and the knitting yarn I used for warp consistently untwisted on one floating selvage.  I switched so I went under both or over both floating selvedges and that stopped the untwisting.

marykayejn (not verified)

Thank you all for your advice.  I had my husband look at the loom, and it was a bit out of square, so we raised the front left corner a bit . . . I also retensioned it a little.  The floating selvage lasted a bit longer this time, but still broke.  Next I'll try using the paperclip temple I used on my towels.  I don't think it's the yarn, since it happened on the towels and this color gamp (I'm using Lunatic Fringe's colors this time).  Cross my fingers, hopefully the temple will make the difference.

Judith (not verified)

Everyone should try the PC temples! They are really quick and easy to set up. I used fishing weights, 4 ounces each side. I find them so much easier to use than regular temples.
Submitted by Anonymous (not verified) on