Weaving with alpaca is tricky I have heard. It breaks, and stretches among other things. Is it possible to mitigate some of that trickiness by using it with other wool yarn such as a stripe pattern, or might that make it worse?  How about using it as weft? Any ideas?

Comments

tommye scanlin

I'm certainly not experienced with using alpaca in weaving; however, I recently completed a project in which I used an end of suri alpaca as a floating selvedge on both sides of a handspun doghair and wool warp.  The piece was 56" wide at the reed and I wove around 72" inches with the alpaca at the edges--didn't break a single time.  I had alpaca being used in the weft, alternating a couple of picks of plain weave of it with a pick of the handspun doghair following.  Again... no problem was found in the use of it for weft.

Sampling is always a good thing although I didn't have time to do that on the project.  So... just saying... in the recent experience in which I used suri alpaca I didn't have any trouble with it.

Tommye

katski (not verified)

Sounds promising. Thanks

jaymio (not verified)

I just finished a scarf using lace weight baby alpaca with silk for weft.  It came out better than I expected.  I had no trouble at all with the alpaca - but then again I didn't know I was supposed to worry about it!  Never broke a warp thread and stretched no more than you would expect from a fine wool yarn.

Ellen (not verified)

I can add that I have woven with baby alpaca several times, both for warp and weft and found it absolutely lovely to work witn. No problems at all. Enjoy it!

EvaHall

I have just set up my Ashford knitter's loom with a alpacca warp, and I am weaving with a woollen weft. This works fine.

BonnieI (not verified)

I have woven many blankets and scarves using Henry's Attic Prime Alpaca, mostly in twills. This is a two-ply yarn, strong enough for warp. It does not shrink much at all with normal wet-finishing, unlike most wool yarn. It will soften when you wash it the first time. Usually I brush lightly while the piece is still damp. Weave, then fringe or hem, then wash, then brush. The result is buttery-soft and warm.

I do not combine wool and alpaca in the warp because of the difference in shrinkage, but you can use all wool for warp and all alpaca for weft or the other way around.  It is possible to create nice textured effects with stripes of wool twill next to stripes of alpaca plain weave, but I had to sample a bunch to find just the right wool for this.

Bonnie Inouye

laurafry

As with anything, it depends on the yarn involved.  Alpaca is a hair fibre and as such needs to be spun tightly in order to prevent it separating when weaving tension is applied.  If you are using a yarn that has been spun with the intention of weaving there should be no problem.  The problem comes when it hasn't been spun tightly enough.

As Bonnie mentions, there could be a problem if you have stripes of alpaca and something else.  If you want to combine different fibres in a warp, the general rule is to alternate them to distribute the shrinkage/take up evenly across the width of the cloth.

Cheers,

Laura

Submitted by Anonymous (not verified) on