I have a drawing I want to put in a draft. How do I get it from a drawing to a drawdown in a weaving progam?

Comments

debmcclintock

so, more detail please,

how many shafts are dealing with in reality?

what is your digital skill level on dealing with jpgs and bmps?

what weaving software are you using?  Good news, bad news, most can handle photos but all do it differently

are you familiar with your fabric analysis module on your weaving software?  you might be able to enter your drawing there manually or paste it in....and then have the fabric analysis convert it to a draft....

lots of directions you can take!

 

BonnieI (not verified)

Weave structure will also make a difference. In general, a tied weave will produce the most detailed image possible with 8 to 32 shafts, and will probably be the easiest draft to create from a drawing. Fabric analysis generally assumes a twill threading, so you might use that for a profile draft instead of a finished draft.

To open a graphic file in weaving software, usually bitmap is the best format.  Note the number of pixels in the image. If the image includes mirror symmetry, work on half the image and then use a point profile threading.

 

Lauries (not verified)

I have Weavepoint as my weaving software. I would use a 16 shaft AVL. I have a diamond pattern from a paper towel. So it something I scanned into my computer. I didn't think of fabic analysis. I am not sure about weave structure it could be a twill or lace weave. Right now I just want to know how.

Sara von Tresckow

Weavepoint will import a bitmap, but be sure that you don't have it at 300dpi - you need to reduce the resolution greatly. You can also "type" the diamond pattern into the "design" window of Weavepoint.

When you change from design to draft mode, Weavepoint will try to generate a draft.

Weaving a "picture" is only "easy" when you have a good foundation in weave structures and drafting. Ulla Getzmann's "Weave Drafting the Swedish Way" is an excellent reference as is Laila Lundell's chapter on drafting in "Big Book of Weaving".

Weaving is a "deep subject" and learning to swim is at least half the fun.

debmcclintock

We have Bonnie I who also answered some of your question above....she has written alot towards designing and understand weave drafts, a book as well as articles.. here is her link:

http://www.bonnieinouye.com/main/page_location_publications.html

What Sara says is true, you need to give it a try on importing your picture into your fabric analysis.  I do not have weavepoint so I can't give specifics but give it a try and see what your system says.  You will probably have to modify it to fit your shafts but I bet you can get close.  In Europe they use twill alot, there are many different varieties, as you read the different books published  keep an eye out for the patterns reflected in your paper towel that you scanned and I bet you will find a draft for it....the towel pattern was probably based on a cloth towel pattern!

BonnieI (not verified)

I do have WeavePoint. With a simple drawing, you might find it fastest to use your mouse and draw directly in the liftplan. Or if it is a normal diamond shape, then you can experiment with fancy tie-ups and use a point twill as both threading and treadling. From your drawing, you might be able to read the tie-up by watching the spaces between diagonal lines.

For a drawing that is an image or motif, make the drawing on the computer or scan it or photograph it. Use a graphics program to reduce the number of pixels and save as a bitmap. Then you can paste the bitmap into WeavePoint.

By the way, the latest version of WeavePoint has some very good tools.

Lauries (not verified)

Thanks for all of your ideas. I have been looking for a diamond pattern before to match the towel  with no luck. That's why I am hopping to get this to work.

Submitted by Anonymous (not verified) on