I have a 'new to me' loom that I am trying to use. When I try to move the cloth forward onto the cloth beam, I have problems. I push the handle toward the loom and down. The ratchet seems to engage and turn the cloth beam like I think it should, but when I try to get a good tension, I don't seem to be able to get the ratchet to engage properly without actually holding the cloth beam in place. I find the whole process very difficult. Do I need to start lifting weights just so I can weave on this loom? But seriously, I am sure that it is my technique, what am I doing wrong? Thanks in advance for any advice given. Valerie

Comments

Cleo

 I am not sure about the Hollandia but if it has the floating front beam you have to set the tension there first so it is parallel to the floor then you release the brake and rachet forward till it is parallel again.  Hope this helps.

steve104c (not verified)

Valeria, The Delta is based on the Hollndia. So, see if there is someone out there who has a Delta, they might be able to give you info. about their loom. Steve P.S. You also might get an owners manual for a Delta and compare (online?).

Amy Weaves Alpaca (not verified)

I am thinking of purchasing a 4H 6T Hollandia. I want to know if I can still upgrade it yo 8H. Does anyone know if the Delta shafts are compatible?

Can anyone share their experience w/ this particular loom?

Joanne Hall

Hi Amy,

Contact Yarn Barn in Kansas.  They are very familiar with these looms.

Joanne

Amy Weaves Alpaca (not verified)

thx Joanne! I will call them tomorrow. Am supposed to pick up loom in the afternoon but not sure it's a good decision.

Val D (not verified)

I have had someone contact me privately with pictures of her Hollandia loom. It turns out that the back ratchet on the cloth beam was upside down. Once I fixed that, the whole process of advancing the cloth was so easy and smooth and incredible. I am so impressed with this 'new' loom. I guess I can put the weights away and get weaving! Thanks for everyones help.

runamuckweaving

The shafts could be compatible but not with the Delta heddles on them. I have both looms and the Hollandia has a much deeper shaft and longer heddles. The set up is the same though on the shaft ends. You would have to have the correct mounting equipment already for an 8 shaft and of course the treadles are quite different between the Hollandia and the Delta, so no substituting Delta treadles. You would need Hollandia ones and the correct plastic hangers for them to add treadles.

Amy Weaves Alpaca (not verified)

Just for the record, I contacted Louet and the Hollandia parts are still available. I ordered a replacement treadle hinge for my loom via Paradise Fibers. I am waiting to hear from Connie at Louet about upgrading the 4H to 8H. She's checking directly w/ the folks in Holland regarding the mechanics. Big thanks to the guys at Paradise Fibers - Travis and Bill - and the gals at Louet - Tammy and Connie. Excellent customer service!

murielsom

I have had my 8 shaft Holandia for 25 years and now have to give up weaving and have not been able to use the loom for two or three years. I have a buyer who very much wants it but we have discovered that some of the plastic hangers/pulleys are cracked. Has anyone else had this problem and does it affect the performance?
Submitted by Anonymous (not verified) on