You all have been so supportive with my beginner's questions. Here's the new one...I'm designing my first project without someone else's directions. I'm confused on "sett" and "epi". Deborah Chandler's book, Learning to Weave, says, "...wrapping the yarn around a ruler for 1 inch... Then divide the number of wraps in 1 inch by two. If this number is12, then the yarn will work at the 12 warp threads per inch..." In The Handweaver's Pattern Guide, Dixon says, "...Wrap the yarn around a ruler... use the number of wraps to determine the maximum sett for your weave structure." So, I've wrapped my thread and it's 24 wraps in an inch. Is my epi 12 or 24? I've got a 12 dent reed, do I put one or two threads through each dent?

Comments

jordanj (not verified)

 Your sett would be 12 ends per inch (epi) and you would put one thread through each dent in your 12 dent reed.

HTH

Jennifer

illoominated (not verified)

So, you're saying you DO divide the number of wraps per inch by 2 to get ends per inch?  The ends per inch is actually how many wraps you get in a half inch?

Sara von Tresckow

 For plain weave, the calculation is not all that hard and fast -

1. measure the wraps in 1 inch .

2. divide by 2.

3. Sett is that number for a fairly balanced plain weave. If you'd like your fabric lighter, subtract 1 or 2 threads. If you need firmer fabric, add 1 or 2.

4. SAMPLE and resley if the initial results are not pleasing.

Guiding Myth (not verified)

 The best sett depends upon a lot of factors.  For a balanced plain weave the best place to start is to wrap the yarn around a ruler for 1 inch and divide by 2 as described in Deborah Chandler's book.  With your yarn that would be 12 ends to the inch.

Other weave structures require a denser sett.  If you plan to weave twill with the same yarn you could sett it closer - 15 epi.  - using a 12 dent reed that would be -1-1-1-2-1-1-1-2-1-1-1-2- in the reed.  Except that a 12 dent reed is fairly fine and a yarn with 12 wraps to the inch is on the thick side.  It may not work to put two  ends of such a thick yarn in such fine dents.  You may not get a good shed.  So if you only have a 12 dent reed - you should probably stick with 12 ends per inch.

Sara's post is right about sampling - this one is about where to start.

Stephanie S 

illoominated (not verified)

Got it.  Thanks, everyone! 

Submitted by Anonymous (not verified) on