I am an absolute weaving novice but have just acquired a "Harris" 8 shaft table loom.  My first of what I am sure will be many questions is:

If I only wish to use 4 of the 8 shafts, do I remove the 4 that I don't need or just leave them in place and bypass the heddles?

Thanks in advance

Mike

Comments

debmcclintock

 Sure you can bypass them.  You might want to put a string thru the top and bottom of the heddles you aren't using so they don't get in your way.  Sometimes they "drift" to the end of your shaft bars.  Split them on the left and right to make room for your warp.

 

zinniz (not verified)

 Hi Mike, you can also remove the harnesses you're not using.  I do that with my Harrisville Design's 8 shaft loom when I'm only using 4 or 5 so I don't have to worry about the heddles on the unused shafts getting in my way.  It's really easy to put them back on when you need them.  I store mine behing a bookshelf so the heddles won't get bent.

Alternatively (especially if you're weaving at a fine sett), you can thread a 4 shaft pattern onto all 8 shafts, where, for example, if the draft uses shaft 1, you might use shafts 1 and 4 (every other thread).  You can think of this just like you would with a straight draw 1-2-3-4 when you weave plain weave.  You technically only needed to use shafts 1 and 2 for plain weave, but when you have threaded 1-2-3-4, you tie up shafts 1 and 3 against 2 and 4.

Mike (not verified)

Thank you Deb and Zinniz.  I think that as an absolute beginner (I have yet to warp a loom) I'll go for the removal of the shafts that I'm not using.

Submitted by Anonymous (not verified) on