I bought a used Dorothy table loom and I really need to clean the bars that hold the heddles....kind of rusty and not clean looking at all.  What would you suggest I use? Thanks for any help.

Comments

sequel (not verified)

I clean them with 0000 steel wool, unless they are really rusty then I might start with 00, and finish with 0000.  Then I rub paraffin on both sides and edges, then buff it. 

This works really well with the blued  spring steel bars, but many LeClerc looms have a painted or plated heddle bar  finish.  This process will work on them too, but they will never be a smooth as the blue steel heddle bars.

I like the paraffin better than oil or silicone as a lubricant, because it doesn't leave any oily residue.

 

 

 

jemwork (not verified)

I've re-furbished a number of looms & rusty is a common condition. I use a dry microfiber cloth to go over everything first - even the heddles, if you aren't replacing them. That gets the worst surface dirt off. All the wood needs to be polished & I use the microfiber cloth again for that. It seems to control how much polish gets into the wood (Spray into the cloth, not on the loom or parts) I really rub it in - wood can be dried out if its sat a long time & dust also dries it out.

After the wood areas are done, I use the same microfiber cloth & go over things like the heddle bars, the heddles (lightly) & other areas. I do not add any more polish. This will take off most of what looks bad. To access the areas I've taken the harnesses off the loom. This allows me to check over how things fit together & see if any cords or chains need replacing.

If the rust is still bad, you may need to take some steel wool to it & then rub again with the microfiber cloth.

If you didn't get a booklet with your Dorothy, LeClerc has a complete list of their booklets at their website. They also have replacement parts for your loom if needed. They even answer your emails fast.

hope this helps - Joan in Jamestown

jemwork (not verified)

Sequel - I like your paraffin idea. I'm doing up two "new" old looms just now. A very old LeClerc Nilec 2H loom (too cute to pass up) and a 4H direct tie-up Dix. Both need some love. I think the Dix has no rust - its metal is aluminum & looks pristine. The Nilec will get some paraffin!

J in J-town

CraftinSusan

I have a LeClerc 2S Nilec too and I also bought it used.  It came without both handles to advance the warp and fabric.  I contacted the seller who promised to look for the handles.  I also contacted LeClerc and asked about replacement handles.  Tom at LeClerc replied to my email quickly with a price quote for the handles.  I was about to buy the handles when the seller contacted me.  She had found the handles.  Yeah!

The Nilec, the Dorothy and the Voyageur loom all use a lot of the same parts.  I checked my Voyageur loom against my Nilec.  The heddle holder is the same for both.  So if the heddle holder on the Nilec or the Dorothy is too rusted you can purchase a replacement from LeClerc.  The heddles and reeds are identical too.

Submitted by Anonymous (not verified) on