I have an AVL Home loom that I bought second-hand. It's in really good condition, but I noticed that the eyes of the heddles are about 1.25" below the shuttle race, when the shafts are at rest (not lifted). This causes the threads to be pulled down at a sharp angle between the beater and the shafts. The threads are all touching the inside top of the heddle eyes when under tension. The beater is at its lowest adjustment.
Is this normal? Should I try to change something to either lift the shafts or lower the beater, or is this OK? It seems to me that this puts a lot of unnecessary stress on the threads.
This is my second loom, and quite frankly, I can't remember if my first loom had this same configuration.
Comments