I'm hoping all you brilliant, talented and experienced weavers out there can help me with this.  I have a 36" 4 shaft Harrisville, and have woven on it for a few years without too many problems, except a tendency for the tension to lessen from right to left, so that the left selvedge always needs more attention.  Nothing undoable, until recently.  I've mostly been weaving scarves and haven't noticed it (due to the width, I think), but the last time I tried towels it was so loose I tried to unwind the warp beam to retie, and of course got nothing but tangles and had to throw the rest of the warp out.  That was only a loss of 1 of 4 towels, but still distressing. Now I'm weaving another set, the first in awhile, and by the mid-point of the first towel, the left side was so loose it literally was as if someone had draped the threads there.  Zero tension.  I don't know what to do.  I've put 4 pens in the left edge of the cloth beam, but it has had little effect. I really need to make these towels (got a craft fair coming up, yay!), and can't afford to lose all that material. 

I guess I'm looking for both long and short term fixes for this.  Can anyone help???

PS I'm weaving with 8/2 cotton, waffle weave.  The other towels were twill.  All the knots are secure and the tension started out just fine and loosened gradually.

Comments

tien (not verified)

My first thought is that the warp is not wound correctly - how are you warping?  What are you using to separate the layers of warp (I'm assuming you're using a plain beam, not a sectional one)?  How are you tensioning the warp as you wind on?  Are you winding on front to back or back to front?

More info!  More info!  :-)

Tien

Sara von Tresckow

Is your loom square???

Are the tieon sticks or apron rods paralle?

Does your loom torque when you tension it? 

Lizbuppers (not verified)

My loom is square,and my hubby's looking at it now to try to figure out the torque question.  Don't have or use tie on sticks, and my apron rods seem parallel.

I warp front to back, lash the warps to the back beam and roll it with a heavy duty cardboardy paper, which I've used from the start.  I wind with the reed all the way forward, then stop and run my hands through the warp and TUG every few yards or so.  It's the way I learned from D Chandler's book. 

laurafry

I'd check the loom first as Sara suggests - also does the loom fold up?  Sometimes one side of a folding loom will start to fold under weaving tension - most irritating!  But it may simply be out of square.

Cheers,

Laura

Submitted by Anonymous (not verified) on