I am new to weaving and have an idea for a project in which steel wires would be woven in the warp and the weft. Is it possible to have different fibers in the warp? For example alternating steel wires and wool? Or would I need to do this on a fixed frame loom set-up?

Comments

flamingo (not verified)

You can certainly mix fibers in the warp. However, steel wire warps are hard on looms and you would probably want to make a "homemade" loom for the purpose. For example, where the wire touches the loom, you might expect some extreme wear. Making a frame loom from steel pipe might work best. Given that, you would probably want to make sure that the wire doesn't rust.

Was it your intent to make much yardage? That might complicate things because the wool and wire will behave very differently. Be warned, steel might kink where you don't want it to and fail to bed when you want it to. Have you considered coated wire?

Michael White

There was an article in "Handwoven" not to long ago about using SS wire. I will try and look it up tomorrow.

Michael

tien (not verified)

And there'sa Weavezine article on weaving with wire: http://www.weavezine.com/content/wired-weaving-wire-rigid-heddle-loom

Submitted by Anonymous (not verified) on