The edge warps always tend to get slack.

What I do is....once I have my warp on the loom and have made my heddles etc.....I untie the start and end knots on the far end loom bar and re-tie those two warp ends a little tighter than they should be. You may need to get someone to help you by holding the near loom bar under tension while you untie and retie the knots at the other end.

If they get slack once you have progressed with your weaving, the easiest solution is to slip a dowel under those warps at the far end and tie the dowel to your far loom bar. I have kebab skewers that are really thin that usually do the trick and I have a collection of dowels of various thicknesses should I need something more substantial.

Other odd warps sometimes get slack  for no apparent reason so it is handy to have the dowel at the far end to take up the slack on all those warps that want to misbehave. One kebab stick or thin dowel can solve the problem for all the loose warps at once.

Laverne

Using a thin dowel to take up the slack on the end warps. The thin dowel will then be tied to the loom bar to keep it in place.

 

Comments

ArcoIris (not verified)

Just taking a break from my very first band (with very loose edges because of slack edge warps) and was so happy to find a ready solution. Thanks, Laverne, this website, and your blog, have everything! You have really inspired me to get creative--something I haven't done in a really long time. So again, thank you.

One question, what kind of knot do you use to secure your warps to the loom bar/warping board? I had a slipknot on the starting side and an overhand knot on the end side. Any suggestions on which kind is best?

Cheers,

Shayna

bolivian warmi

Hi Shayna,

Good to hear that you are finding your way around and have been able to find solutions to your problems. No matter what is going on with your band or warp, you can be sure that someone else has had the same problem at some stage and when a new question comes up I make a FAQ page for it.

So this is the second question about knots that has come up recently and I have a certain knot that I use. I have never known its name but Michelle in France tells me it is probably a bowline. My Navajo weaving teacher taught me this knot and I find it is the best when you are trying to tie a warp under tension. You want to tie that last warp on your warping board taround the stake leaving a lrage loop without losing your tension.

The start warp is not so important-any knot will do that will allow you to have a large loop in your warp tail so that it can be easily slipped off the stake and onto your loom bar.

Once I have my warp on the loom, I get someone to hold the loom bar under tension while I undo the knots at the far end and retie the warps  tighty around the loom rod.

I think that I will start a new FAQ page and do a diagram or photo of the knot I use-there are probably diagrams of it in every standard knot book-I just need to pin down the correct name and then others will surely come along and tell us what knots they use. I love learning knots, BTW-I used to do rock climbing and that was half the fun of it.

Looking forward to seeing pictures of your band when you are ready.

Laverne

scottishlamb

Shoot.   I just saw this.  Now I know. lol.

Submitted by bolivian warmi on