Hello:

I'm a new weaving and I'm hoping someone can help me out on this towel project...

The project had 480 warp ends, but there's a note that the designer removed one end due to the pattern leaving 479. Sett: 24 epi / Reed: 12 dent / Sley 2 threads in each dent--but this leaves me with one thread at the end and I'm not sure what to do with it. Should this be left on it's own in a dent or should I group it with the previous 2 and have 3 in one dent? Not sure if this matters, but the directions also requires floating salvages on both sides. Any information would be much appreciated. THANK YOU!

Comments

debmcclintock

Put the one lonely thread by itself and give the floating selvedge it's own dent.  There is less chance of the threads hanging up on each other.  At 24 epi you shouldn't see the difference.  Depending on the structure you could also do as you say above and put it with the previous 2 but sometimes the structure shows a crowded dent as a streak in the woven fabric.  

Submitted by Anonymous (not verified) on