I have a newly acquired Harris 8 shaft table loom.  The reed is obviously attached to the swinging arm of the beater, but also attached to this swinging arm is a triangular shaped piece of wood running across the width of the beater.  Please see the attached photograph for an idea of what I am trying to explain: the piece in question can be seen below the warp threads.  My question is _ What is the purpose of this additional bar across the beater.  Should the loom be warped such that this piece is within the shed rather than underneath the warp threads?

Comments

Sara von Tresckow

That is a so-called shuttle race, intended to assist the shuttle when gliding from side to side. It provides a bit of support on the slightly loose lower shed of a rising shed loom. It is positioned correctly as shown.

Mike (not verified)

Thank you Sara

Regards

Mike

Submitted by Anonymous (not verified) on