Hi, Here are some pictures of a piece of "equipment" that came with my new "used" Glimakra Ideal.  I thought it was some kind of raddle, but Joanne hasn't seen one like it, so I thought I'd toss is out there to see if anyone has an idea of what this is? I thought I could clamp it on the inside of the back beam and use it as a raddle?? Thanks, Brenda

                                                                                                      

 

Comments

debmcclintock

are the nails staggered?  maybe 1/2 inch increments..maybe it is laid somewhere on the loom so the warp threads travel up and over both sides on the way to the warp beam?  swag!  Deb

borthober (not verified)

Hi, Deb,

Yes, the nails are staggered.  I hadn't noticed that!  Here is a picture of the entire piece...it is about a yard long and about 1 1/2 inches wide...the nails are 1/2 inch long and spaced 1/2 inches apart. 

                  

 

 

't

debmcclintock

hmmmm, now I don't have a working knowledge of your loom, but maybe the person who built this raddle did not have one either! (never forget that equipment sometimes doesn't belong with a loom)

Look at the back of your loom or maybe somewhere in the middle....is there somewhere to hang/wedge/support that raddle by the notches so that the warp travels up thru the nails on one side, over the board and down thru the other side nails onto your warp beam?  (Effectively using both sides to divide warp by 1/2 inch segments)

Plan B could be that you just pull the nails out one side and use the nails on just one side, but maybe someone can come up with another answer for you!  take care  Deb

ps, another thought that just occurred to me is that the Swedish way is to put a raddle or reed cut in half in the beater and wind onto the back beam and have your threading cross in the opposite end of your warp chains in order to thread the heddles.  I don't wind my warp that way but see if this unnamed device fits in your beater....if it does I bet that is what it is...circle back to Joanne and ask her for the proper names for that process

Joanne Hall

I too noticed that the nails are staggered.  I agree with you that the person who made this was not familiar with any ordinary warping technique.  I would set it aside, plan a warp for your new loom and not worry about it.  Use your reed as a raddle like the Swedes do.  Raddles were popular in the past when reeds were made of wood.  They were used for spacing the warp for beaming, which then saved the reed from extra wear.  Now reeds are very strong and the raddle is not necessary.  And reed size 12 or coarser can be used to space your warp for beaming.

Joanne

borthober (not verified)

Thanks, everyone...I appreciate your input!  Brenda

Michael White

I am thinking that you have a raddle with 1/2 inch and on the other side  1inch spacing? From the picture the pins are not straight through?The spacing could be metric.

Michael

Joanne Hall

Or if the nails do not stagger evenly,  maybe one is 1/2 inch and the other 1cm.  It is possible to get raddles in 1 cm spaces.

Joanne

Submitted by Anonymous (not verified) on