I recently purchased an older CB loom that has a sectional warp beam.  My previous loom didn't have one and I've never done sectional warping before.  The sectional beam has original wooden "spikes" spaced every 2 inches, but the previous owner pounded nails in between the wooden spikes to make 1 inch spacing.  The nails look  REALLY  bad and I was wanting to remove them.  Is it better to have 1 inch spacing for sectional warping?  I don't want to remove them if 1 inch spacing is much more effecient or a lot easier/better.   Any comments are appreciated.

Thanks and GOD bless you!

CC

Comments

loomroomcat (not verified)

You wouldn't need as many spools of warp if you wound 1" sections.  Personally I would remove the nails and warp 2" sections, I think it would be less time and less work.  Depends on how finances figure into your situation.  good luck!

1gardenia (not verified)

I have a floor loom that has 2" sections.  I would always complain to my husband about all the spools that had to be done in order to fill those 2 inches.  But after buying my table loom, which has 1" sections, I'd rather work with 2" sections  

a. it does not take as much time to roll the threads

b. and when you have 45" to thread, it seems to go faster than when you have 1" sections. I guess it is just a feeling because you have the same number of threads.

So, I guess it is just a matter of preferences.

Chantal

tien (not verified)

It depends on what you're weaving and your equipment.  If you are using a 2" spacing, you will need to wind double the number of spools (if you are using spools) that you would for a 1" spacing.  If you are weaving at 12 ends per inch, doubling the number of spools is no hardship.  If you are weaving at 40 ends per inch, that would be a lot more spools to wind AND you might run out of room on your spool rack!

The other advantage of 1" spacing is that it gives you more options for warp width.  With 2" spacing, your warp must be a multiple of 2 inches wide when beamed on.  You can fiddle with that some by sleying the reed more densely than the warp is beamed on (e.g. by sleying 24 epi when it's beamed on at 23 epi) but then you have to do the extra calculations.  With 1" spacing, you can beam on any whole number of inches.

An expensive-but-handy alternative to a spool rack is an AVL warping wheel, which allows you to wind the sections without having to wind spools.  That's what I have, and it's a real timesaver for me, since I weave at 40-60 epi most of the time, and my loom is only 24" wide.

Submitted by celtinbirks on