I live in an 'alpine semi-arid' climate and despite running a humidifier at full blast, the static electricity is awful.  I've just wound a biggish warp and while doing it, both the thread and my hair were standing up like we were connected to a Vandergraf generator.  It's the closest to a halo I'll ever come.  Now I'm trying to sley the reed and the threads are just about lifting off the cross all by themselves.  Please, please, can anybody help me with this?  Rubbing the chains with a fabric softener sheet doesn't help~

Comments

celtinbirks

What about misting the threads with a very very fine spray of water?

celtinbirks

What about misting the threads with a very very fine spray of water?

handspunhandwoven (not verified)

Jeannie -

I also live in the 'alpine semi-arid' climate, so I feel your pain. I've used water with a dash of fabric softener in my Misto for years for all of my carding, spinning, and combing. Especially the combing, as the fiber pulling through the steel tines can really build up a charge. Judith turned me onto this life saving little device some time in the distant past.

http://www.amazon.com/Misto-Sprayer/dp/B0002MQZ2I

You can see the current humidity in my loom room, and that's with the humidifier running. The Mistos are fabulous - they spray a very fine mist and you don't wear your fingers out pulling the trigger. You just pump it up using the cap and mist away.

They carry them at Bed, Bath, and Beyond, and William Sonoma at Flatirons has them too.

Michael White

What type of yarn are you using? The type of yarn and what you are wearing will make a big difference. What is your floor made of?

Jeannie (not verified)

BB&B, here I come.

Michael, I was wearing cotton, the floor is bare wood, and the fibre is probably rayon - no label in the cones, but the burn test tells me it isn't wool, cotton, or linen.  It's kind of a crepe, not at all fuzzy, and there is a shiny thread running through it.  The effect of the static is pretty impressive, I should try for a photo.  :-)

Thanks all for the suggestions.

Michael White

Jeannie, sorry that this has taken so long to get back to you. Try this: get a piece of solid bare copper wire, 10 gage (from hardware, big box store or electrical supply house) long enough to go across  the back bar(so your yarn passes over and touches the wire) and down to the floor. Now you can go to Radio Shack an get a static discharge band or you can make one. To make one, from the above suppliers get enough 18 gage wire with a jacket to go from the 10 gage wire to your treadles and then add a extra two feet. Strip one end and attach this to the 10 ga wire. Strip a long lenght off the 18 ga and rap this around your leg (or do this with the static band) Now you are one with your loom( at the same electrical potential) This will not hurt.

Michael

Jeannie (not verified)

Hi Michael,

Thanks for replying.  I'll try that too.  I did, at one point, have a vision of myself trailing grounding chains.  :-)

Joanna

Michael White

Joanna, you can not "ground" yourself to a wooden floor. Try the wire thing and let me know how it goes.

Michael

Slipstream (not verified)

This may be overkill but there is a product that looks iike Christmas tree garland that is conductive.  It is used in processing systems to dissipate static electrricity, especially in sheet products.  It basically just contacts the product as it comes off the processing equipment and is connected to ground.  This site has a good discussion on the stuff and no you can't use Christmas tree garland because it is made out of a non-conductive plastic usually.  Here is the URL http://www.statictinsel.com/takk-antistatic-questions.html

Best regards,

Charles

Submitted by Anonymous (not verified) on