I have a five-yard piece with 16/2 cotton warp and 16/1 linen weft in a 2-block twill that I would like to wet finish before sewing into roman shades. I have two smaller pieces that I can wet finish first to test the results.

If you have any warnings or suggestions from your experience, I'd be so grateful.

Comments

laurafry

Wet finishing a cotton/linen blend is fairly straight forward.  Personally I would use the washing machine for such a large piece - warm water, gentle wash/spin (if you don't have gentle spin, can you stop the spin cycle independently?  On my old machine I would stop the spin as soon as the water no longer gurgled down the drain pipe.)

Dry until damp, then apply a hard press or cold mangle to compress the warp and weft threads together.  Since a 5 yard piece will take a lot of time to hard press, a cold mangle would probably go faster.  

Cold mangling is compression without heat and can be done using a large roller on a hard surface.  I have a video clip on You Tube

http://www.youtube.com/user/LauraAnnFry1

Scroll down to the cold mangling clip.  While I am using a wooden dowel in the clip a pvc pipe can also be used.  For the large number of samples I did in Magic in the Water I actually used a very large pvc 'pipe', laid the fabric out on my kitchen floor and sat on the pipe.  :D

cheers,

Laura

KarenIsenhower

Thanks, Laura, for your expert advice! I don't have gentle spin on my washer, but I can stop the machine at any time. I suppose that a hard spin might "set" creases or wrinkles in the linen??

Your video on cold mangling is very helpful. Hmm, I can't quite picture sitting on the pvc pipe to roll it across the fabric. Maybe I can get my husband to do that part. :) Not likely...

laurafry

Yes, a swift spin can set pretty permanent creases.  :(

Well, the pvc 'pipe' I used was about 24" across, not a small 6" one!  :D

cheers,

Laura

Submitted by KarenIsenhower on