i am pretty new to weaving.

Have not done anything in years.

I want to weave dish towels.  I know that I need 5  yds of warp for 4 towels.  I used a warping mill for the first time.

I got all done winding the warp on the mill, and discovered that I should have doubled the length!

I have 2.5 yards of warp........................am I just going to have to scrap that warp and start all over again?

Comments

laurafry

Or you could just dress the loom as an exercise and weave two towels?

cheers,

Laura

endorph

to suggest the same thing Laura did - I'd go ahead and warp and weave two towels.

Claudia Segal (not verified)

I third the suggestion.  There is no need to scrap the warp.  Beam it on, thread the loom and weave!  It's a great way to get back into the sport.  Then, when the towels are done, you can cut them off in front of the reed and tie on the next warp to the current one and the sleying and threading are already done.

Happy weaving,

Claudia

ReedGuy

However, depending on the loom, there could be a full yard of waste from the tie on at the ends including the section behind the fall line of the shed and the tie-on bar at the back. But if it comes down to it, between tossing it and weaving, weave. ;)

tmendicino

It's a small Harrisville folding loom. It looks like it will be tight to with the waste, but I to was thinking tye on and weave the rest of the towels. thanks again for the advise. I will let you know how it goes.

Submitted by tmendicino on