Hello all,
I am a new weaver, working on a little old English Dryad counterbalance floor loom. I've read a few tips online and in one of my books about adjustments for getting good sheds when treadling tie-ups that are "asymmetrical" 1 against 3, etc. I've played around with the length of the texsolv cords between the lamms and the harnesses, and a bit with the length of those above the harnesses. Some improvement seemed to be happening, but I still need to really stomp on the treadles to open a fairly clear shed, except on the symmetrical tie-ups.
There's lots of advice about this kind of thing online, but everyone seems to have either rollers above the harnesses, or one large pulley and horses. Some recommendations have been to raise the top pulley/roller, but that is not an option for me, although I could shorten the cords from the top pulley to the smaller pulleys. I haven't tried this. As you can see in the first photo below, the Dryad has one upper pulley, and two smaller pulleys, on each side. The second photo shows a problem shed.
Also, I am having irregular sheds that seem to be related to the harnesses pulling unevenly, and sometimes remaining that way even at rest. I've shown this in the third photo, and the fourth shows the wonkiness remaining, even with the treadle released. You can see a bunch of unused heddles down at one end of the last two harnesses, but they aren't connected to anything but the tops of each harness, and aren't responsible for drawing it down on that end.




So, my questions are:
1. Are any of these problems worse BECAUSE the Dryad has pulleys rather than rollers or horses? If so, I could think about modifying it.
2. What would you advise I try, and it what order? Originally I was most bothered by the poor sheds, but probably the uneven bit is more of a problem?
Thanks to all you experienced counter-balancers; I have already learned so much from your discussions!
Jennifer (Textilis)
Comments