This is the first time I have warped my sectional beam...the first section went on smoothly...the second didn't go on so well. I somehow broke a warp thread and the whole section has appeared to go on funky. See the slant in the blue section? Will this cause tension problems? Any thoughts on what might have caused this problem? Right now, I wind a section on a warping board, then run it through a tension box while winding in on the beam. Should I try re-beaming it? (If yes, any tips on how to do that?) Thanks so much!!

Comments

laurafry

It is important to have the threads aligned within the section during beaming, preferably under tension.  Just using a tension box doens't, in my experience, provide sufficient tension unless there is a weight holding the threads as well.  Personally I have not had good results from winding a one inch (or two inch) chain and beaming as you have done.  If I want to beam a warp onto a sectional beam but use a warping board, I'd much rather wind the chain, then just beam it as it, allowing the warp threads to find their own place on the beam, making sure none of the threads get caught on the 'rakes'.

I have photos on my blog - I think if you click on the label sectional beaming it should come up in the queue.

http://laurasloom.blogspot.com

cheers,

Laura

sammyjain

Thank you for the reply!  I will look at your site!

That's what I am afraid of.  I am waiting for a warping wheel and got a little impatient.  :) I was holding tension with my hand as I was cranking...but you know how that is.

The url that I posted above will send you to the picture.  

laurafry

That small amount of descrepency won't likely cause any issues with a cotton warp.  If it were linen, it might, but that really isn't a huge amount.  Ive seen far worse!  :D

cheers,

Laura

sammyjain

phew!  Thank you - you've made my day.  I was sweating how I was going get 21 yards off and back on...without tangling.  

Any suggestions on how to evenly weight the next session - rather than using my hand?

sammyjain

phew!  Thank you - you've made my day.  I was sweating how I was going get 21 yards off and back on...without tangling.  

Any suggestions on how to evenly weight the next session - rather than using my hand?  I wish I had some sort of trapeeze set up.

laurafry

You can use most anything. The big thing is consistent weight. On my small loom with plain beam I have a couple of bleach bottles with handles. I tied a cord to the handle. Then I loop a circle of string around the chain and attach the bottle to the loop with an S hook. You won't need a huge amount of weight for such small chains. Just be consistent... Cheers Laura

sandra.eberhar…

I add extra dowels to my tension box, or run the warp over/under loom beams to add extra tension.

Submitted by sammyjain on