Hi,
I have been searching an answer to my shuttle problems all over the net but found no cues.
I have a thin wool scarf on my loom. The loom is Scandinavian (Toika) countermarche loom. The warp is tripled (yes that´s right) thin lambswool and alpaca and 5 ends per 1cm. The weave is barleycorn/broken twill. I use small boat shuttle with upward pointed ends. The sheds are clean and tension as tight I dare to pull with delicate yarns. I use tripled weft as well. I know by this far this project is made up of ´not-to-dos' but everything looks neat.
The problem occurs with two sheds (2 and 4) when I am throwing shuttle from the right to left. I have analyzed my style of weaving but I seem to make pretty much the same gestures on both sides and sheds 1 and 3 work fine.
I have tried lowering the reed but the bottom shed is good to begin with. I have put extra care to bobbin winding. I beat (or put the weft in place) when switching sheds so I can clear the shed for next shuttle round.
Am I to accept that my shuttle will stick until the end of this warp? Usually it catches near the middle of the warp but there´s no mistake or gap because of cords or heddles. I thought I would ask advice before I surrender with this project. I know here´s so much talent and experience that could point me to the right direction.
Also one other question has been troubling me. What kind of boat shuttle goes well with my kind of loom? I have only used that one because I have never seen anything else for sale in my corner of the world. For instance swedish-type boat shuttles are extinct in Finland even though we´re close neighbours. I am interested in a little bit longer shuttle (mine is 10.5") and would love to hear recommendations for one.
Thank you all for your advice and have a good day
Niina
Comments