I just completed weaving some baby blankets in a heart pattern.  I really liked the little hearts, and decided to warp my loom to make a dozen or so bookmarks.

Used the same 5/2 pearl cotton for the bookmarks as the baby blankets.  So why is the size of each module so much shorter (less length) for the bookmarks?  This isn't the first time this has happened to me, but it is the first time I've been really clear about it.  

You'd immediately think I was beating the bookmarks harder, but in fact, I can barely touch the beater to the front of the loom and it's packed in too hard.  I've loosened the warp, tightened the warp, no apparent impact. 

FYI, the blanket had 496 ends, the bookmark 45.

Thanks for your insights!

Comments

Karren K. Brito

It's ten times harder to beat the 496 ends than the 45.   You can verify this by counting the picks per inch on both pieces.

One technique to lighten you beat is to change when you beat.  You can let the shed close and beat on the closed shed or open the next shed   and beat then.  Think place instead of beat.  Watch the little open spaces around the threads in the web you are weaving and try to keep them the same size--square or rectangle that they are.

kerstinfroberg

Karren said: it is ten times harder... - which is why small samples don't tell the whole story!

The only time I really, really sampled... I made 4 or 5 different samples, different yars, different setts etc. Found one quality I liked.  ... whatever I did (temple, double - triple beating etc) I could NOT get it as tight as the sample. And I thought I did not BEAT the sample(s)...

One of my old weaving teachers always say the rule of thumb is that the full size weaving should be sett about 10% more open (here we have the "ten times", again)

tien (not verified)

That's been my experience as well.  The narrower your sample, the denser your sett can be.

I found this out the hard way when I wove my wedding-dress fabric.  My sample was 4" wide and wove up beautifully at 96 epi (!).  I tried the same 96 epi on a 24" wide fabric and it was a NIGHTMARE!!  I finally had to back the sett down to 72 epi (a 25% decrease) and even then it was still sticky.  60 epi worked a lot better on a subsequent warp the same size - a sett decrease of almost 40%!

When I wove up the fabric for my Kodachrome jacket, I learned my lesson and wove the sample at 12", then widened the sett by about 10% when I wove the actual fabric at 24".  This worked perfectly.

My recommendation is to re-sley your bookmarks to a denser sett.  Of course, working with a very narrow piece, it might wind up too narrow...so maybe a combination of denser sett and a lighter beat?

peg.cherre (not verified)

Thanks for your suggestions, and for confirming that it wasn't me!  For this purpose, I decided to use some brightly colored carpet warp I had for the weft, and to beat ever so lightly.  They're just bookmarks, after all.  But I will sley closer next time I decide to make bookmarks.

Happy spring!

wv60epi (not verified)

There is a good explanation of this in Osterkamp's book #1, page 93. "With a narrow warp on a big loom, the beater will tend to pack in the weft more than on a wide warp on that loom. You can expect a wider warp to need to be sett a bit more open than your narrow sample was on the loom. It's the friction of the threads in the reed that prevents the beater from packing down the wefts as much as it would with a narrow warp." Her warp calculation suggests and advice were invaluable when planning a very wide commission!
Submitted by Anonymous (not verified) on