Sorry for all the questions lately but I am teaching myself and have no local guild to find guidance. After reassembling my harnesses I cannot seem to get them to match up in length. Do I need to retie and adjust their height with the treadle cord (meaning the cords that are connected to the treadles, tie-ups maybe)? I didn't touch that one at all when u took them down. I am so baffled by this, I don't know where to adjust. Also, what is the preferred height of the harness, since some are high and some are low I don't know what height I'm aiming for. I have a 4T 4H harrisville loom. Thanks.

Comments

sequel (not verified)

Shaft height should be 8 1/2" from the top of the castle crosspiece to the top of the shaft frame.  Adjust your shafts frames using the tie-up ropes at the treadles.  The treadle tips should be below the lower crosspiece at the back of the loom.

tanukitextiles

Why would the harnesses match up in height before I took them off and not after, if I didn't touch the tie-up ropes at all?

sequel (not verified)

When you took them off they probably shifted position of the upper cables.  These are adjusted by pulling and tugging on either side of the upper cables at the point where they are connected to the lower ropes by an S-hook.  You slide the do-hickey up, adjust the cables to level the shafts and slide the do-hickey back down.  The do-hickey slide is copper on the looms with leather upper cables, and a gray metal with parallel holes for the black nylon coated new style cables.

Submitted by tanukitextiles on