Alison (not verified)

Hi Caroline -

They are using Betty Davenport's books.

Alison

Caroline (not verified)

Just wondered since Claudia couldn't find the picture. We still have the older book turn up here on ebay quite regularly!

mischiefmanaged (not verified)

I've been looking around for an old strong small picture frame or something like that to try this out (not having an extra clipboard laying around . . . although who knows what I'd find if I cleaned out the laundry room . . . ). Looking around my craft room, I found a PVC lap quilting frame that I got when I tried out rug hooking. I think it is about 11x11 inches and I plan to try it out next week!

francorios (not verified)

That lap quilting frame should work.

Let us know how it goes!

Have a good day!

Franco Rios

mischiefmanaged (not verified)

Here it is, not a clipboard, but another simple portable loom. It's a PVC pipe lap quilting frame but I guess you could get PVC pip and corner pieces at the hardware or home improvement store and make your own. I warped mine according to the directions for a Hopi belt loom in Mary Pendleton's book Navajo and Hopi Weaving Techniques.

\

 

The left edge of my warp is messed up, but it's fun to venture into two colors!

francorios (not verified)

That looks good. I could certainly make them with part from the hardware store.

That's a good start on your band.

Keep it up. It gets better.

Have a good day!

francorios (not verified)

The long pieces with the cut out strip can be made using a utility knife, sometimes called box cutters.

Use new PVC pipe because old PVC gets brittle and hard to cut. Avoid electric saws because the saw may catch the plastic and cause it to shatter.

Buy a pipe a little larger than the other. The larger would fit over the smaller.

Have a good day!

Franco Rios

mischiefmanaged (not verified)

Hi Laverne -- don't know about the corner  or other pieces; Franco, do you?

The shuttle I bought new on ebay; it is meant for an inkle loom and is beveled. It works well as a beater on narrow warps. The make is Finniwig Studios.

Cindy

rose Goldielocks (not verified)

It is frustrating! to cut the PVC to make the "clip" portion of the PVC quilting frame. When I tried, I found it almost impossible to get a 'straight' lengthwise cut. (mostly because of the structure of the plastic grains inside the pvc pipe).

Cutting a straight horizontal line is not a problem. A box cutters (utility knife) works pretty good for 3 or 4 cuts on the pvc. The easiest way is to mark the place to cut all the way around with pencil/pen/perminant marker and then ROLL the pipe on a flat surface while applying pressure with the knife.  If you have acess to a 'miter box' or a 'hack saw', that is the best choise.

Sharon

francorios (not verified)

I sorry my advice did not work out for you.

I've cut PVC lengthwise with a box cutter before.

I checked the web for other ideas and this page

http://www.pvcworkshop.com/freePVCplans.htm

recommends using a handsaw or or dremel tool.

You mentioned a miter box and I believe the handsaws that are used with miter boxes have fine teeth which should work on PVC.

Have a good day!

Franco Rios