Ellen (not verified)

Hi Kurt,

Sounds like you are pleased with the twister, then. I must admit that to me it sounds as if it is more work using it than doing it by hand. But of course if the result is better... I find that it only takes me a few moments to twist a fringe, and I don't have to clip and unclip and count and hold anything. Just my fingers and the yarn.

I'll be looking out for you blanket on the projects page :-)

Ellen

Loominaria (not verified)

Kerstin's tri-twister is here. I have never seen one like that on this side of the pond.

Kurt

Loominaria (not verified)

 OK, but you have to call me Kurt instead of Kurk.

francorios (not verified)


Okay, here's my scarf after I cut it off the loom. (click picture for larger view) For this project I am using twisted fringe as described in the instructions for the log cabin pattern found at
http://www.schachtspindle.com/Newsletters/Newsletter2005Spring.htm

Working groups of 5 strands, 2 of one color and 3 of the other, I twisted the group of 2 tightly, twisted the group of 3 tightly, twisted those 2 groups tightly in the other direction and tied a knot to make it 6 inches long. Read the newsletter. Note: The newsletter describes making a table runner, I just changed dimensions to allow for a 6 inch by 72 inch scarf.

Next step will be to wet finish.

Have a good day!

Ellen (not verified)

Hi.

That looks really good. I read your description, and looked at the link. And this makes me wonder : Do you really twist first one and then the other, and then twist the two together? ?

I take the two groups of threads in each hand (after tying a half-knot) and start twisting the right one clockwise, and at the same time keep putting the right one over the left one, until I reach the end both, and then tie a knot. (This results in both strands being twisted the same, as it is alternating strands I have in my right hand). I hope this makes sense. These things seem harder to describe than do :-)

Nice scarf!

Ellen

francorios (not verified)

Well, I did just that.

I twisted one group clockwise until it felt tight, I kept the yarn taut so it would not kink on itself. Then I twisted the second group clockwise, holding the first group twisted and tight. Then holding the two groups, I twisted those groups together counterclockwise, then knotted them.

The opposing twist tension holds the twisted fringe in place.

Which makes sense to me because I also spin fiber and this is how spun yarn single ply is turned into two or three ply, the ply twist is opposite of the spin twist for best structure.

Your turning process sounds interesting. I worry that it won't hold up to wear as long as the twisting process.

Have a good day!

Kurt Pippin (not verified)

Like Franco, I twist as spinners spin and ply. I put the ends or groups of ends in the clips of the twister and twist in the direction that the yarn was plied, i.e., adding twist, then I gather the twisted ends together under tension in one clip, and twist in the opposite direction, about 50-60% as much as the first twist--aiming to match the diagonal angle of the original yarn, so it's balanced.

I'm much less 'scientific' when I'm doing it than when I'm describing it.

Pippin

jenadina (not verified)

 Interesting...I twist fringes with sort of a combination. I hold one group in each hand and twist them both at the same time in the direction of ply (adding twist), then switch hands, then twist, then switch, twist, switch, etc.  For example, if ply direction is twisting clockwise, I roll both groups (one in each hand, remember) between my fingers to add twist, then switch the strands left under right. I use my pinky finger to pull the left strand over. 

This way, the twisting and the plying is done all at the same time, and I don't have to try to hold one strand taut while twisting the other :)

Ellen (not verified)

That is exactly what I do, and tried to describe above, only you seem to have done it a lot better!!  And I find it very easy and quick to do. Great to heear that I am not the only one :-)

Ellen

Kristina (not verified)

Hi Ellen,

I am still always impressed by your beautiful cloth. Where did you get this beautiful pattern/ draft and how many shafts you have woven. I'm looking forward to see it at the project site. But mayby you can already give me a hint .

 Greetings from windy Germany!

Kristina