KokoSam (not verified)

I am in a Muddle ...that's Muddle with a capital M!!!

I hope someone may be able to help me get out of my Muddle efficiently, quickly and without too much pain. ggg  I am about to weave a fine cotton and rayon stripped material for a blouse. It should be about 35" wide and about 60" long, set at 34epi. I have several different merc. cottons and a rayon boucle these are to be in stripes of 8 and 13 ends across the width. Now my problem:  I very stupidly forgot and wound each chain in groups of 100 instead of stripe ends!!! I thread from back to fromt....so you can imagine the mess at to back!!!! I can normally manage to have a muddle at the back of the loom, but this...  A friend suggested winding on from the front I have never done this and with this very fine warp along with the rayon, I'm not sure that this is the warp to learn on!

Any help would be apprecialted Cheers Judy

KokoSam (not verified)

Hi Laura,

Thanks for your help, no I don't have enough yarn to wind another warp, so I really would prefer to find a way to salvage this one, if I can.  I certainly understand that it is sometimes more cost effective to waste the warp and wind another, except this one has some very special (not to mention expensive) yarns in it.  What if I cut this end of the warp configure them the way I need and then just tie them together? It would probably mean that I would lose the cross, but I should be able to work it out later, and it wouldn't be the first time I have threaded up with out a cross. As I see it - it would also mean unchaining and removing all the chock ties. Does that sound feasible?

Thanks again for your help and I am really pleased to hear that you are regaining your health.  Cheers Judy

 

 

trishSA (not verified)

I second the motion to warp front to back - but I warp that way 90% of the time. Hopefully you have one cross still  on the far end of your warp chain. You can use that one for easy sleying. Just wind carefully when it is time to beam your warp on - make sure there are no tangles in front of the reed and that the threads are moving smoothly through the heddles . Wind on a small amount - then stop and check for tangles.  I think you can be successful and get the warp you want going front to back. Good luck!

Maisyandme (not verified)

Laura,

I'd love to know more about basket weave selvedges. Do you have a resource handy that would give me the lesson that I need?

Thank you,

Avery

kalama (not verified)

I like warping front to back. I can rearrange stripes or not even worry about   winding the warp in the stripe sequence. Just sley it in the order I like. You do have to be a little more careful beaming, but there is always a trade off.

Alaire Rieffel (not verified)

You are right--these are hemostats, only too coarse to use on blood vessels during surgery!  Same idea though.

Cheryl Muckenfuss (not verified)

 I am just making such a change: selling two large looms located in my basement & replacing with a Louet David to be in my dining room.  I hated the unfinished basement and feel such a relief now that I can weave above ground LOL!  I think it  is important 'where' we weave.

Andreweaver (not verified)

Have you got it on the loom yet?

I have only just joined and so I didn't pick it up before.

I often make my warps in sections each section may be a different yarn and different colour I then sort out in the raddle before winding on. The only time I tried warping front to back I lost the lot. It was a hairy tweed yarn if I remember right. I use several back sticks so put the back loop of each section on each stick then they can sit above each other and all get tied to hen spread each warp section seperatly bottom first into the raddle. A good bang at the choke tie on each layer and it should all settle neatly. If you realy want having raddled them you \can amalgamate the sections all onto one stick but I don't find this is necessary.

Just my thoughts.

Andrew.

suehelmken (not verified)

I've been using copper wire on the loom for a while now.  Lately I've tried shaping the cloth and attaching it to weathered wood I collect on hikes.  I plan to try more things as I collect them.  It would be great to talk with others doing things with non-standard materials.  I don't have much of the newest work on my site yet, but it's coming.

Sue Helmken 

[email protected]

www.barefootweaver.com

Orion (not verified)

 Well, I was weaving with "normal" fibers until I took a class from Patricia Morton involving weaving with plants.

Now, my daffodils, irises and other plants are being eyed very suspiciously.

I wove my plants into an eyeglass case and plan on making some purses. 

I guess you could call it grass cloth but it's a lot of fun to weave.

The current issue of Handwoven has an article on plant weaving by the woman who taught my teacher :-)