francorios (not verified)


Okay, I had a false start a couple of days ago. I warped up the loom, for a 16 inch wide by 24 inch long towel using Peaches & Creme white for most of the warp/weft and Sugar & Creme variegated black/white for borders. I adjusted my craft frame and tied the loom bars 24 inch apart. I continuous warped the loom bars. My camera ate the pictures of what happened next.



I tied edge cords onto both ends of the warp so I could get a nice finished edge (selvedge) to the piece. Then I moved the loom bars so I could lash the edge cords to the loom bar, I set a couple of dowels into the warp to hold the crossing of the warp threads (cross). This held up for while and I was able to get myself ready to weave by sitting on the couch with the other end of the loom tied to a bolt attached under a counter top.

As I tried to arrange my sticks, I learned that I had crossed a few warps. Bummer. And my edge cord had missed a few warps also. Bummer.

Then I tipped the loom sideways and the cross sticks fell out. Bummer. I tried to use a pickup stick to recover the warp cross. Very slow going and not very successful. I was extremely grumpy about this turn of events. If I lived in a more primitive setting, I would have gone out and shot a buffalo.

I untied the whole thing and started over. Ahhhh! Much better. I found that double checking every warp and cross doesn't take time, it saves time. Rubber bands are a fast way to tie up the ends of leash sticks to hold a cross. Tying a safety string across heddle and shed sticks also saves time.

More in next message 5000 character limit is cramping my style.

francorios (not verified)




Here I am on the second try. I saw pictures of people sitting on the floor with their backstrap looms and so I though I would try it. It's not bad. I need more cushion for sitting. Also need a cushion under my knees to put a little bit of flex in my knees to keep from hyper extending the knee joint. Otherwise it's not bad. I had joked about my legs being too short for my feet to hold the far end of the loom, 30 inch long trouser leg, and it turns out it is not a problem when weaving a 24 inch towel!


Here is my view of the weaving. The loom bar at the bottom is tied to my belt strap. Then it is tied to the lashed edge cord dowel. Then we have about 2 inches of black/white border to go with the two inches of black/white warp border. There is a pickup stick that is used to hold open the shed for the stick shuttle to go through. There is the string heddle on a stick, with a safety string. Behind that is another flat stick for making a shed. Then a round shed stick, with a safety string. Then the far edge cord dowel lashed to the far loom bar. And finally, a loop of rope to go over my shoes.

Did I mention that safety strings save time?


Here is a picture of the string heddle in action, holding up a set of warp for the shed stick to go under.


Here is the really cool part. You can put your shuttle stick on top of your work in progress, then start rolling from the loom bar until you get to the far loom bar and you now ready for transport! Most of the loom parts are 18 inch long, the heddle stick is 24 inch long, but still easy to pack and move. I can cut down that heddle stick.

Have a good day!

Caroline (not verified)

My commiserations, Franco, but it looks pretty good in the photos!

It took me longer than I thought to get my own mess back into shape, but its coming along nicely now. I did learn one thing though, lol!

If you are going to weave at night, don't use a black continuous warp! It has to be the hardest thing to re-heddle, grrr!

I've rigged up a pulley system attached to the window frame  that I can attach the backstrap to. I do, however , have a few doubts as to how much stress I can put on it before the whole window drops out. That aside, it should work well, otherwise I'll be down on the floor too exercising my toes! I suspect I shall have to start moving all my furniture around, hehe!

daisey27 (not verified)

Hi

Am I right in thinking that if you weave a warp faced fabric you have one colour on the bottom and another on the top. and if you weave a weft fabric you use thinner warp threads all one colour and thicker weft threads/yarn so it will show more?

Karina

francorios (not verified)

More Backstrap weaving


The next morning: After weaving to the middle of the piece, I turned the loom around and started weaving from the far end. I will end my weaving in the middle of the piece and have all four sides with finished selvedge. With about 3 inches of weaving to go, I remove the flat shed sticks and use 3/8 dowels to hold the sheds.

In the picture above, the upper most stick is a shed stick, with safety string, holding the upper shed. The lower shed is controlled with a string heddle stick, which is flopped down so you can see the upper shed stick.


In the next picture, we see the string heddle moved up over the upper shed stick so you can see the lower shed. which I have opened with a 3/8 dowel. This dowel has a flat wedge on one end put there by using sandpaper. This helps me to push the stick through the warp to open the shed.

When the shed is open, I push the weft through with a needle made from a chopstick, which is in the picture. If I try to pull the weft through without that shed stick holding open a space for the needle, the weft drags through the closed warp (shed) and pulls the warp out of line. It also becomes difficult to keep the right amount of slack in the weave. My chopstick is not long enough to go across on one throw. So I used the blunt end of a plastic crochet hook to push it the extr 4 or 5 inches out of the shed (see the small yellow plastic rod in the lower right of the picture).

To beat the weft, I am using a pet grooming comb with metal pins for teeth that happens to have 1/4 inch spacing, which is just right for my project. I can also use a dinner fork if I need to.

More later!
Have a good day!

Caroline (not verified)

I'm up and running too! This is my view of my backstrap in action.

It could still do with a few refinements, but the cats think its a brand new toy, just for them!

This is the unholy banana silk yarn, thats as flexible as mild steel, particularly if you are silly enough to think it will bend back on itself to go into the next shed. But the colours and texture are lovely, even if its a bit hard to handle.

I've put a large hook into the wooden window frame, behind the curtains, so when not in use it hangs out of sight. I have a pulley system so I can adjust it for all length of warps, and remain seated on my sofa in comfort. Please note the spare shoe laces - the non-stretchy woven cotton ones are really really useful, and the knots stay tied! The yellow nylon bricklayer's twine was not a good choice, as it comes undone as soon as you look at it, and tangles before you have a chance to touch it.

Bonnie Datta (not verified)

Hi Everyone.  The photos and commentaries on setting up a loom are so helpful.  Thanks everyone.

My question is: Does anyone set up their backstrap so that the woven web is far and the unwoven warp is near?  That kind of set-up would have derived from warp-weighted weaving, and would require the beat to be away from the body rather than towards it.

I do tablet weaving on a vertical warp-weighted arrangement, and I really prefer it to any kind of loom where the textile and the warp are fixed.  The live weight "gives", just as is possible with a backstrap, and that makes it so much easier to get the hands in there for patterning, while still being able to beat on a very tight warp.

Bonnie.

 

ilaine (not verified)

Handy listing of New York Guilds - there is spinning, weaving and knitting. Those of you in the further corners of New York State may find something in your area:

http://www.textilelinks.com/guild/ny.html

sweltwoman (not verified)

I'm the Program Chair of the NY Handweavers Guild and we'd love to have you join us!  We have great speakers scheduled for this coming year.  We meet the last Saturday of the month at the School of Visual Arts in Manhattan.  Check out the web site for details.

ilaine (not verified)

Nov 14 a new exhibit on the Silk Road will open at the American Museum of Natural History. The exhibit will include video of weavolution's own WormSpit - see his blog:

http://wormspit.com/blog/?p=1412