I am weaving a header on the rug on my loom and every time I try to toss the shuttle across the warp, it fall through the warp threads onto the floor.  It gets tangled in other threads and I have a heck of a time fixing things.  How do I get the shuttle across the loom?  I am using seine twine 12/6, sett is 10/inch and 39" wide on my 45" wide loom.  The tension is as tight as it will go, I am around the knee beam on the from and tied onto the front apron bar.  I have about 6 picks total and I did these by passing the shuttle across the warp manually a few threads at a time after it fell 4 times.  I do not have enought web to put the temple on yet, although I hope to have enought in the next 5 or 6 picks.  This method is very tedious and I am certain I am doing something very wrong.

Thanks in advance for any suggestions.

Claudia

Comments

sequel (not verified)

Sounds like maybe you have a loom without a shuttle race. 

Try a longer shuttle so it will bridge the gaps between the warps, but at 10 epi that should not be your problem.

Make sure you have a clean shed - all the threads that are down are evenly down so your shuttle can travel across them. 

Shuttle tips may be too low, sometimes a problem with low profile boat shuttles. 

Make sure you are throwing the shuttle from a level start, not lifting the backside up as you fling the thing across!  (This happens often when you are reaching across a wide web.)

laurafry

In addition to the above, how are you holding your shuttle?  If you hold it 'overhand' (dangling from your fingers with your palm down) it is difficult to 'throw' the shuttle across a wider web........

cheers,

Laura

Claudia Segal (not verified)

I have a countermarche loom so there is no shuttle race per se.  I am throwing overhand and will try the underhand method and a longer shuttle.  Thanks all.

Claudia

loomroomcat (not verified)

do you have a ski shuttle?   I find these helpful for weaving headers.  Or a long stick shuttle.  With a countermarche the shed is so narrow that you need a short ski shuttle like a glimakra that is relatively flat.l

Weavin Steven

For wide warps and no shuttle race, I use a double-feed shuttle with as long a bobbin as possible. This also adds a benefit of not having to wind as many bobbins, thus reducing the number of threads that need to be tucked in.

Submitted by Anonymous (not verified) on