I want to weave a band about 25 inches long.   Warp faced weaving will shorten the length of the piece, so how much should I allow for this weaving shrinkage?   Is there a percentage or general rule for estimating length?   Have a good day!

Comments

bolivian warmi

I don't have a general take up percentage I can give you.

I imagine you are wanting to make a 4-selvedge piece.  I have never really tried to make a precise length with 4 selvedges where I had to take this into account.

The backstrap I made for the WeaveZine article was a one-yard warp and I made four backstraps-2 plain and 2 with pick up patterning.  I will measure them up and see what I come up with.

Laverne

 

francorios (not verified)

I need a 25 inch band for a hat band. I want to use up some wool yarn from another project.

So I want to plan length and width based on a limited amount of wool. The longer I make it, the narrower the band has to be. I want the band to be wide so I can play with warp floats.

I just need a general take up percentage. I'll make a test piece, measure the shrinkage, and try to estimate from there. Maybe between your measurement and mine we'll figure it out.

Have a good day!

bolivian warmi

Franco,

I wound a 1 yard warp with my 12 wpi cotton and wove a band with warp floats. I started on a needle and wove until there were 2 1/4 inches of warp remaining which I left as fringe.. The band not counting the fringe measures 27 3/4 inches.

It was one of the sample bands for the tutorial.

The hat band is a cool idea!

Hope this helps.

Laverne

 

francorios (not verified)

Thanks. That's about 77% net weaving, so I bet if I warp a 36 inch starting on a wire it would work.

Thanks again!

Have a good day!

rose Goldielocks (not verified)

I use about 36" warped for a pickup hat-band using size 10 crochet thread.

This allows for about a 2" fringe and about a 2" overlap.

Another sample I warped at 26" turned out to be 25 1/2" long, but it was in small size thread, and only had 2 pairs, (total 8 strands in middle) that had pickup on it.

Standard 'warp faced' shrinkage in most weaving books is 10-12%... so that means take your 26" hat band (allow a little bit to sew together, and multiply it by 1.10. so that is 26 inches times 1.1 = 28.6 inches, so warp 29" .

 

Sharon

 

Caroline (not verified)

Warp shrinkage also has to take into account the size of the yarn used. If you are using a very fine yarn, the take-up will be less than if you are using PnC or SnC.

francorios (not verified)

Thank you Caroline and Sharon,

My wool yarn is about 12 wpi, so I'm proably closer to Laverne's estimate of 23%

But I'll keep the 12%shrinkage number in mind for the crochet thread projects I have coming up.

 

Thanks!

Have a good day!

Submitted by Anonymous (not verified) on