Hello to all, and welcome new members! Earlier this month while viewing another weaving site a thread was active on Warp Spreaders. A member there asked an interesting question. It seemed to them that the spreader would be better served with the opening on top instead of the customary design of the opening on the bottom. However if one were to turn it over it would surely drop through the warp! Since I was about to make a pair of these little gadgets anyway, I decided to do what I like best, "innovate"! My design is open to the top, won't fall through, tapered to pass easily between the warp.It's made of a bit of black walnut from the scrap box, really only costing the time to make them. Oh! did I mention, they work! Great fun!, Frank.