Anyone care to share their favorite technique for maintaining an even width when weaving bands? 

Thanks,

Jennifer

Comments

bolivian warmi

Well, knowing your yarn helps and what width you can expect to get from it on a warp faced band.

Then I think it is a matter of being consistent with the way you lay in the weft and beat. I like to lay in the weft and pull it through while pinching the edge of the band so that I can't pull the weft through too tightly and bend the outer warps and, therefore, cause the band to pull in and get narrower.

 

Bonnie Datta (not verified)

I've only done bands in tablet weaving on a warp-weighted set-up.  Here are things I did to keep edges from drawing in:

1.  Like Laverne said, know your yarns -- sample and experiment to get the width/texture that suits the yarn and the object being made.

2.  Mark the width on a piece of tape on your beater or sword and eyeball it routinely -- now and then deliberately line up the marks with the edges to be sure you are maintaining the width.

3.  Insert the weft, but leave a loop at the edge where it enters the shed.  Change the shed and then tug the weft, pinching the point of insertion (as Laverne also suggested) so you can feel the tension where the weft wraps the selvedge warp.

I have made tablet woven pieces with deliberately curving sevedges.  For example, the strap for a bag can be woven loosely at the ends where it forms the sides of a carry-all, then can be tapered to a narrower band to go over the shoulder.

Bonnie.

jordanj (not verified)

 Thanks for the quick feedback! I have been doing the "pinching" thing and I think that helps a lot, but I'd still like to be more consistent. I like the idea of putting tape on the beater. That would be a quick reference. I tried the hanging gauge in the Davenport book, but found it awkward. I think now I just have to practice, practice, practice!

Thanks again for the quick replies!

msthimble

Hi Jordan! I am new to inkle weaving, too. I realized that I need a control to stop the warp from spreading out at the start of the band. I am making one inch bands for dog collars, so what I do is this- when startign the weaving, make a "up" shed, lifting the warp up. Insert a toothpick in the shed, as if it was a thread. beat and change sheds. Now you will begin weaving. Tie your weft to the right side of the toothpick, weave a pick. After the weft yarn exits the shed, wrap it under the left side of the toothpick, make sure to adjust the width exactly. Make another pick. After the weft yarn exits the right side, wrap it under the right side of the toothpick. Now with your craft scissor or nail clipper, cut of the points on the toothpick so you dont get stabbed. Essentially, you have created what would be the the harness loom equivalent of "lashing on to the front beam". Now continue to weave as usual. When you finish the band, remove from the loom and stitch close to the toothpick before removing it. This method has reduced loom waste for me. In addition, I use a white colored pencil to mark my shuttle with the desired width of the weaving. The marks wear off after repeated beating. XO Gail & Fog
Submitted by Anonymous (not verified) on