Hello everyone,

 

After a few months of trial and error I am finally weaving on my floor loom!  The only thing is that I am having a slight tension problem.  When I throw the shuttle it seems to let out too much yarn, so that there is excess at the selvedges.  I find that with each throw I am having to kind of wind some of the thread back in or pull it through manually a bit so that it doesn't all bunch up.   Is this just due to my lack of skill in handling the shuttle?  I'm sure that there is a lot of technique to getting it right, any tips?

Please bear in mind that I am a complete beginner, so sorry if this is a silly question.

Comments

tien (not verified)

What kind of shuttle are you using?  If you are using a boat shuttle, you will want to catch the shuttle and hold it with your thumb on the bobbin to keep it from unwinding further, then pull it through just until there is no loop at the selvage.  Leave the yarn at an angle to the fell (where unwoven warp meets woven fabric) to give it room to go over/under the warp threads as you beat the yarn in.

Does that help?

Joanne Hall

can sometimes occur when you leave too much weft out of the shuttle before you throw it.  Watch what you do with your hand and arm before you throw it.  It is not necessary to pull any out or to hold the shuttle far from the selvage.  When you throw it, there should be no extra pulled out and your hand is very close to the selvage.  When you catch the shuttle, keep it close to the selvage when you beat.  I have seen many weavers swing their arms far from the warp when catching and throwing a shuttle.  This is a habit that may result from the bobbin catching, but this should not happen.  They compensate by pulling extra out before throwing the shuttle, just in case the bobbin catches.  Don't do this, as it causes the loops of weft at the selvage.  So, watch what you are doing and keep the shuttle close to the selvage.

Joanne

Submitted by Anonymous (not verified) on