I am hoping to make the Shades of India kitchen towels as shown in Handwoven Magazine March/April 2015. The draft calls for 3 ends of each color in the color sequence. I dress my loom back to front. I think that I saw a post from someone having a similar issue and the suggestion was to wind 4 ends and weight one end off the back of the loom (as I would a repair thread). I have already wound the warp and it is sitting on the warp beam, with the cross safely secured in the lease sticks. To my calculation, I will have 140 or so threads hanging off the back of the loom and I am worried about compromising the cross. Does anyone have any suggestions? Yes, I am a newbie. Yes, this may not have been the best project choice, but it will be a learning experience for sure. Thank you for any help offered.

Comments

Artistry

You're right that's too many warp ends to have hanging off the back beam !the weighted  ends will twist up making a mess, giving you problems with your tension. 

you warped 4 ends instead of 3 ? I would go ahead and thread all 4 . But there is a problem now. Since you warped more ends then required you may not have enough weft ( if it's one of the same colors as the warp) to finish the project. what brand of yarn is it? You could try to get some more, or, pick out a totally different weft yarn of the same kind of fiber and weight, or, make one towel smaller.

there are several ways to handle color changes in the warp. If the color changes every so inches then I cut the warp end and attach the new color using an overhand knot either at the top peg ( if it's an uneven # end like 53) or at the bottom peg ( if it's an even # end like 54 ) DO NOT cut the ends in the middle of the warp to change color , that will give you a knot while you're weaving that you'll have to contend with.

if  the color changes are every 3 threads this is what I do. I warp those ends and completing the length to the last peg, then go to the closet empty peg , on the same side and wrap around the empty peg several times holding that color in place. Start your next color , and do the same. Pick up your original color , undo the wraps and warp it. You will have a small cross over in the loops at the bottom of the warp. This is o.k. , it will get cut off eventually. If you have to change colors at the top of your warping board and there is no peg around to secure that color, just use a piece of painters tape or masking tape to hold it in place ( masking will leave residue painters tape will not).

i thinks that's it ! 

Cathie

 

Gabbyweaves

Thank you for your help. One more question? Can I use an overhand knot at the top of my warp on the warp beam?

Artistry

Do you mean Warping Board ? The answer to that is give it a tug to make sure it's going to hold , otherwise use a square knot ! make sure your knot is at the peg not too close to the cross, and, the tails of the knot are trimmed to 1 inch at the longest.

if I haven't answered your question please elaborate :)

good luck and happy weaving !

Cathie

Gabbyweaves

Thank you so much Cathie for both your insight and your patience!

 

jmbennett (not verified)

I own many since I do better with visuals but don't have a weaving school or guild near me.  Two videos you may find helpful are by Madelyn van der Hoogt: Warping your Loom and Weaving Well.  They usually come up on sale on the Weaving Today (Interweave) website store.  Good luck with your towels!

 

Jamie in Western KY

Gabbyweaves

Thank you Jamie for both the video suggestions and the wish for luck!

Submitted by Gabbyweaves on