Hello, Now that I have an 8-harness loom I remember someone telling me at one time that I could weave a 4-shaft waffle weave with plain weave edges, which would use a total of 6 shafts. For the life of me I cannot figure out how to thread for that and how to tie up the treddles. Any suggestions? Of course, one might not want plain weave on the edges, I don't know, but I was never very happy with the edges of just the waffle weaves. Thanks!

Comments

kerstinfroberg

As you have 4 empty shafts on your loom, I suggest you thread your selvages on all four.

Add plain weave to those extra shafts in yout tie-up:

To fix the double ends on the left side, just shift the left end one shaft:

As plain weave is not the best companion to waffle weave, I did some more "doodling" on my blog - "On adding borders".

Hope this helps!

ilovefiber

Kirstin.  I do not know if I thanked you yet or not. Shame on me if I didn't.  I am going to try the variation you have on your blog site with the twill border today.  Thank you so much!  I really need to find a good book that teaches how to design drafts or take a class but have not found a class yet.  Again, thank you!!!!!!!!  M

Sara von Tresckow

Kerstin's draft will give you nice tabby edges, but what is going to happen after wet finishing?

With cotton, waffle shrinks up to 30% while the tabby at most 10%. You might want to test a narrow sample before starting any large project.

ilovefiber

Sara,  I am planning on having twill edges like Kerstin showed on her web site.  I think it will be okay.  IMO it cannot be much worse than waffle edges, as I only have 8 threads of edge on each side.  Will keep you updated and thanks for the heads up.  Perhaps I need to learn the hard way LOL.  Will do a sample and wet finish.  Can always resley those few threads.   Thanks and happy weaving!  M
Submitted by ilovefiber on