Problem with fell of rug becoming unparallel to breast beam. Worsens as weaving progresses. I think the cloth or warp beam, or both, may be twisting under the high tension I use for rugs. Any thoughts? It's an old Orco 70 2-harness counter balance loom which I've modified - overhead beater, reversed treadles, raised for walking loom, and continuous warp from a spool rack. -greg

 

Comments

sequel (not verified)

First, the brake on this loom is only on one side and that may be your only problem.  You've reworked most everything else, so why not make a rig to brake both sides?  The second and more troublesome culprit, may be that the beam itself is torque-ing out of square.  I've seen this on the 45" Hammett looms.  I put in diagonal crossbracing with wire and a turnbuckle.

Joanne Hall

The most common cause is from not putting your hand in the center of the beater.  Rule that out before you make any loom changes.  Some of the older rug looms had a handle on the beater to make sure one did beat with the hand in the center.

Joanne

greg woods

Thank you. I considered that and have a handle which I'll put on the beater.

greg woods

I did add bracing. I'll check to see if the loom is still square. If not, I'll add more. Any information regarding making a rig to brake both sides? I also considered that possible remedy.

sandra.eberhar…

You may want to check with Bruce at Kessinich' they make the Orcos.  I've not needed a second brake on my 48" rug loom, but do have one on the 8'

greg woods

Thank you for the referral. I did recheck and the loom is square. And, I'm stacking my hands in the marked center of the beater, now. 

sequel (not verified)

Sorry to not be more clear.  On the 45" Hammetts, also with a brake on only one side, the open beam itself was twisted.  I corrected by using wire and turnbuckles on the inside of the beam to pull it back into alignment.

greg woods

I looked at the beam and it doesn't appear to be torqued.

sandra.eberhar…

Things that I have seen cause uneven wind on- an apron with a hem on one side,  Uneven tie on, cloth beam crooked, cloth beam warped, these might give you some ideas

ReedGuy

And to add, the tie-on rodmight be bending because the lashing cord is spread too wide or narrow for the warp. The warp and the cord have to work against each other.

Submitted by greg woods on