I wound a 9 yd., 416 thread warp of 8/2 cotton.  It is through the reed and a third of it is through the heddles. (FTB)  The pattern calls for 6 accent threads.  I could not find my yellow accent color when I measured the warp so used white instead (I figured I'd lost the yellow thread in a recent move).  I found the yellow accent thread this morning.  I am not an experienced weaver...will the following work?  I want to trade the yellow accent threads for the white ones I already used.  Can I thread a yellow thread with each of the 6 white threads and tie the two threads together behind the heddles, and then pull the yellow threads right along with the white ones when I pull the warp through to the back of the loom?   I might have some tangle issues in front of the reeds incorporating those yellow threads into my warp - I'll put each yellow thread on its own sewing thread spool (any better idea?).  However, when I wind the warp to the back beam, the yellow threads will go with the white threads.  Then, I'll clip the white threads out of the reed.  What do you think?  Is there an easier way?

Comments

Bonnie Datta (not verified)

I think that you can just make your six (9 yard long) accent threads, and secure them with ties.  Then pull out the six white threads from your existing warp (one at a time).  Then sley and thread the yellow threads along with your main warp.  I've done this type of thing and I'm sure you'll have no problem.  Now, if you were warping back to front, and already had the whites rolled on the beam it would be a different story -- you would have to unthread the whites and leave them dangling, then thread the yellows and weight them over the back beam.

I hope I haven't misunderstood your question...

Bonnie.

 

Karren K. Brito

Sounds good to me.  I don't think you need the extra spools, just make a yellow warp of the same length as the first one and lay it on top of the big one and tension them together. 

Submitted by Anonymous (not verified) on