Hi,
I am new here and I have had a search but haven't found an answer so I thought I would just jump in and ask. Apologies if this has already been aswered and I missed it.
I have a four shaft Levard table loom, a no 13 I believe, and am using it for the first time. It came without a manual, the previous owner had lost it. I was fine, despite having switched the warp from a rigid heddle to the Levard, until I got halve way though threading the heddles (I was working from the back beam to the front). I had followed instructions of dividing the heddles by 8 and putting 1/8 on each side of the four shafts, but then I realised that because of the way the shaft bars attach the heddle bar to the handles, it meant that the warp wasn't even. The bars are attached at different positions on each heddle bar, wth a difference of 2 3/4 between the first and last bar.
Am I making any sense?
I am puzzled as to know how to figure out how many heddles to use on each side of each shaft as each one will be different. Does anyone else have this type of loom or the instruction manual for a No 13? Is there an easy way to do this? Should I be warping front to back rather than back to front?
Any help much appreciated!
Comments