I keep having a problem while weaving an overshot runner with catching the ends on the teeth of the temple.  I never realize it for a few more throws and then have to painfully unweave (using end feed shuttles).  How can I prevent this from occurring?   I look at each edge after each pass but they hide under the temple sometimes.  I am using a wooden temple as it is a relatively fine weave. I also have a floating selvedge on each side.  If I don't use the temple I can't keep the proper epi.  Suggestions?  

 

Cleo

Comments

sally orgren

Slide the temple end-cap over the teeth when weaving. The end cap that came with my Toika temple is a small plastic tube that has a beveled slit cut in it.

If you don't have these end caps, perhaps you can make something similar? What about embedding a small piece of firm styrofoam or foam over the teeth when weaving? Or find something fairly rigid and tubular at the hardware store, and slit that?

I prefer the Toika temples because they are very low profile — they don't block a lot of your woven surface. They have fine teeth, contrary to what you may have heard about metal vs wood temples. I also have a wooden one with fine teeth, but I am unsure of that manufacturer. You'll notice the wood one has essentially the same silhouette as the Toika-skinny in the middle, especially when fully extended.

P.S. I used the temples shown below to weave the overshot placemats for a guild exchange posted here at Weavolution, also using end-feed shuttles.

 

Tikkunknitter (not verified)

Has anyone heard of Signe's Width Holder (a/k/a Signe's Stretcher)?  I think it's a kind of temple, and I'd love to see a photo of one, and perhaps get information about where I might find one.  Thanks for any assistance you can provide.  Leslie (a relatively new weaver)

Weavernoes (not verified)

I found this info there:http://fibre2fabric.blogspot.com/2007/12/end-feed-shuttle-tension-selve…
Sherry said...

See if you can track down a 'Signe's width holder' , they're made in Canada. The address I have is 40 Kingsford Cr., Kanata, Ontario, K2K I24. You attach it to each side of your loom, and once you have about two inches woven, you attach it to the selvedges. As you weave, you move it forward. It works like a temple, keeping your web taut, hence... nice, even selvedges and no temple in your way and/ or weighting down your weaving. If you e-mail me, I can send you a picture of one in action. I use it for everything I weave. It is one of the best doodads that I have bought for weaving, the best being an end feed shuttle. Sherry = [email protected]

21 February 2008 06:38
I know, it's not recent, but....
You may see this address on Google maps, but nothing interesting (apparently)

SallyE (not verified)

I don't have trouble catching my weft on the temple teeth, but I sometimes poke myself in the hand or arms.   The solution I came up with is to put binder clips over the ends of the temple once it's in place on the cloth I'm weaving.  The largest size fits on well, but you do have to lay the little handles flat on the fabric top and botton so you don't catch the warp on those.

 

 

mrdubyah (not verified)

Yes!  Well said!  I've been using binder clips on the warp stretchers and, if you don't fold down the little handles they're sure to grab a pick when you're not looking. 

Submitted by Cleo on