I am attempting my first 'Big" project.  I have aToika countermarche and currently have a 16M warp of 30/2 silk on 8 shafts for a Swedish snowflake weave for stoles.  My weft is also 60/2 silk, but the issue is in the warp.  I am having one heckuva time with this sticky silk!  I expect mohair to be sticky, but silk?  I've only begun weaving the first stole and it's taking me a very long time to get this moving because of the stikiness.  Are there any suggestions out there for mitigating this issue?

Many thanks

Comments

Sara von Tresckow

To clear the shed on a sticky warp, use an "afterbeat" - a light tap on the changed shed that serves to shake the threads into proper order. You may wish to use a lighter first beat to prevent your weft from being too firm.

Alison (not verified)

The afterbeat works well for me too.  In my dry dry climate, I've found that a little antistatic spray sometimes helps.

Also, have you sampled your sett?  A denser sett increases the problem.

Has anyone had success with sizing a silk warp?  I have not tried this.

Let us know how it goes and post pictures!

Alison

Sara von Tresckow

I've put a light sizing of laundry starch on silk with good results.

 

Su Butler

What is your sett??  Silk can pill a little causing sticking of neighboring threads, but a CM loom action should really take care of any of that.....humidifying the room will help, as will rubbing a fabric softener sheet over the warp rather vigorously. 

Can you elaborate a litte more on the specific problem you are experiencing??  Is it possible you have some crossed threads within the heddles??  There are a lot of things that could behave in a way to make you think the warp was sticking.....

Su

 

 

ScarlettLux (not verified)

Thanks so much everyone for the ideas, I will certainly try them - All.  Anything is better than fixing the warp every single pick.

A little more about my project:  I wouldn't consider it an extremely dense sett, but I wanted the fabric to be both light and dense enough to show the Swedish snowflake pattern well.  The sett is 40.8 epi (160 epd) and I have it sleyed 4 ends per dent in a 40 epd reed.  I don't have any Imperial reeds so pretty much everything I do is Metric.  There are no tangled strands, I've gone through them about 3 times by now (at 700 ends that was time consuming)  There is some pilling, and the stickiness only occurrs within the dents.

Looking forward to any other wisdom you see fit to extend!

 

Crystal

Joanne Hall

Hi Crystal,

You must mean that you have a 10 dent reed with four threads in each dent.  Perhaps a 20 dent reed would be a better choice and may reduce the pilling.  But you may also find that if you advance the warp frequently and only beat once, that the problem will go away as you start to weave the warp where it has not been handled as much.

Are you using a temple?

Joanne

Su Butler

HI Crystal......30/2 silk is generally sett between 30 and 36 ends per inch for plain weave to twill.  So your 40 epi sett is fairly dense.  That could be part of the problem.  I am a little confused about your sett...but am I understanding correctly that you used a metric reed - 40/10, which is 40 dents per 10 cm.  That would translate into a imperial reed that was 10 ends per inch.  If you sett your warp at 4 ends in each dent, you would end up with a working sett of 40 ends per inch.  That is a pretty dense sett, even for silk.  With four ends in a dent, the yarns could be abraiding and catching on one another in the dents.  If this is the case, I would get some child's hair conditioner, the kind you spray on a childs hair while it is wet to loosen tangles so you can comb through it without pulling the hair.  Spray the warp before it goes through the heddles and if you have to, while it is close to the dents.  Your other option might be to open up your sett a bit, say resley 4,3,4,3,4,3,4,3,4,3 for a sett of 35 ends per inch.  That little bit might make a big difference in the sticking problem. 

Hope that helps....

Su  (P.s. - for some reason red silk always pills on me....no other colors just red.....do you have red in your warp??)

ScarlettLux (not verified)

I don't have any Imperial measurement reeds, just metric, so no 10 dent reed although I am considering buying some reeds that measure in inches instead of decimeters.  It can get confusing doing all of the conversions from American weaving patterns.

I am not using a temple.  I was taught to not use one, but I may consider it for this bad boy. :)

 

Hey Su - I am following the sett prescribed by two different patterns, one from a blog on Swedish Snowflakes by Evelyn Oldroyd and the other from the Silk Snowflake and Stars pattern on pg 55 of The Best of Weavers Twill Thrills book.  They have 30/2 silk set at 40epi and I liked the look of the material it made.  I also made up a sample (but did not wash it) and again I liked the way it looked and felt, the pattern is of utmost importance in this particular piece.  I will take pictures when I can get a bit more going and have something nice to take a picture of!  I am definitely going off to the store for child's hair spray conditioner.  I had been trying water spray which does help a bit, but the conditioner may help even more.

My warp is gold, and I dyed it myself, so maybe that's got something to do with it.

 

Oh well, come hell or high water I will get these stoles woven and will post some pictures.  Thank you all so much for your help.

Sara von Tresckow

 Why switch to inch weaving? I started metric and since it is easy to visualize the number of threads in a centimeter, and there is no dealing with fractions - simply sliding the decimals, it makes no sense for you to switch if you don't live in the US.

When dealing with fine warps such as yours, whether you have 60, 61 or 62 threads per inch isn't going to make much difference anyway.

For crossover points - 1 yard is 0.9m or 1m = 1.1 yd

1 foot (12") is 30cm

1" = 2.5cm 

10cm = 4"

Dealing with yarn and fiber isn't as exact as something like wire gauges. Since most reeds are made in countries who use metric, there isn't much point in getting different reeds when a simple calculator will convert for you in seconds.

 

 

 

 

lkautio (not verified)

I've had good luck with gelatin sizing with a very sticky silk warp.  It was a much thicker singles which I also had to rebeam to a more open sett.  Stickiest yarn I've run across outside of brushed mohair.

Laurie Autio

Submitted by Anonymous (not verified) on