Hi. New weaver, again :). My project's warp is on the loom. Yipee! I am weaving a bamboo shawl. I am just starting and was wondering what is the best way to even out the spaced left by tying on to the front apron rod?

Comments

laurafry

I start with some waste yarn, throw one pick, change the shed, throw a second pick, change the shed and throw a third pick. THEN I squeeze all three picks together. Throw a few more picks beating as usual and it should be good enough to start weaving your project. Cheers Laura

moraine

Went back and lashed on smaller tread groups. I then followed the above method. Took about an inch and a half and now I am ready to start weaving. Wish me luck! I want to do a perfect job.

laurafry

Perfection is a process. With each project you will learn more and the closer you will come to 'perfect'. :) Cheers Laura

mrdubyah (not verified)

Sounds like you're all set now!  For future reference, you can also throw two picks in each shed, going across and back and leaving a loop at the selvedge each time.  That way when your project is done and off the loom you can just pull the loose end and all the waste yarn will slip right out! 

calebsb

I like to split each edge section into two ties with smaller gaps, since for me the edges seem to take longer to behave.  The bit you weave with the junk shuttle is also your chance to equalize the tension in case the tie-off created any slack.  For this reason I often start with something thin to get more picks over the same distance (as long as I don't plan to pull them out for fringe later).

ReedGuy

Or use cord and undulate it between the warp like in this photo. Cuts down on waste. ;)

Submitted by moraine on