According to my directions, I'm supposed to resley my reed from 2 threads in a 10 dent to 3 dents in a 10 dent.  Since I had to pull the threads out of the 10 dent reed anyway, is there any reason I should keep the 10 dent reed and do 3 threads per dent OR would it be better if I just used my 15 dent reed and put two threads per dent. Same epi, right?   It's not hard to change out the reed on my loom. Still learning...

Comments

sally orgren

It might be better to keep the more open reed (10 dent), so the warps have room to slide past each other when changing sheds. Rep weave is warp-faced, so the sett is typically very close. You will also be less likely to abrade warps (and break them!) if they rub against each other, verses the hard metal of a dent.

(If you want to see some rep eyecandy, check out repweaver's project posts here on weavolution!)

Sally

Submitted by Anonymous (not verified) on