Hi everyone,

I'm new to weaving and new to this forum.  I bought a Dorothy table loom on Craigslist, a newer model which had never been used.  I can't get a proper tension because... I think... the brake on the side doesn't work properly.  Any advice about how to change this out, or is there someone out there who repairs and refurbishes these little jewels.  I have a table runner all ready to go, I warped, threaded, and sleyed, but I can't weave anything because the brake isn't holding.  Help!  and thanks!  Jackie in Texas

Comments

sequel (not verified)

Check your manual to see if the brake band is wound correctly.  You can adjust the tension by taking a link or two up on the Texsolv cord.  Make sure you are winding the warp in the right direction on the beam - it goes straight up and over the back beam at a right angle while the cloth goes in a zig-zag over the breast beam and the cloth beam.  Here's the link you need to look at the pix, page 11:

http://leclerclooms.com/cat_leus/2011US.pdf

quepasoJackie

Thank you!  ... that helps a lot!

Submitted by quepasoJackie on