I`m owner of an old Ullmann Jack loom, that was a gift. Now I have put Texsolv heddles on it of the correct size, but I can`t move them on the shafts. Its to hard to move them. So threading is an adventure because I don`t see anything.

Has anyone same problem ? What can I do? The shafts are from metal , no wood ...

Regards

Martina

Comments

sequel (not verified)

Did you clean any oxidization off the aluminum heddle bars and wax and buff them well?  A friend has one of these looms and hers came from another weaver with twisted wire heddles that had the heddle loops opened up into circles.  I thought Texsolv would be better, but not if they don't fit.  As I recall, there is no way to relieve the tension on the heddles as you thread them.  Aren't the bars fitted into holes in the shaft frames?  If there is a center clip?  Releasing the clip may give you enough flex in the bars to slide the heddles while threading.

Coraeick

I cleaned the heddle bars and buffed them.I think the texsolv heddles don`t fit good enough, there are a little bit too small. And I cannot relieve the tension...And there is no center clip. I think, I must find another solution...

Thanks Sequel!

Gone

I don't know how your harnesses are set up, but.......suggestion. If your heddle bars go into a slot in the ends of your harnesses, and your harnesses are wood. You could take the top bars out (or the bottom) and use a fine hacksaw  blade to lengthen the slot EVER so slightly, up or down. (Like mabe 1/16") That might free up your heddles bars to flex a little.  Texsolv comes in 1/2 inch increments so it's unlikely you have the wrong size. If they were too small, they'd be pulling 1/4 inch top and bottom / Too big and you might lose shed.

sandra.eberhar…

Metal heddle bars are designed for wire or flat heddles.  You may be able to change it to texsolve, but why would you want to do that?  If it was a very large loom and you wanted to make the shafts lighter, I could see that.  Wire heddles are so much easier to thread, I don't see why you would want to change to texsolve.

sequel (not verified)

The Ullman smaller jack loom I've worked with had round heddle bars and wire heddles and the place for the heddle bar was stretched into a round shape to fit.  There is no slot to lengthen, there are holes, similar to the holes on the sides of the Glimakra Viking shafts.  Hand tied heddles to use until Coraeick decides if she wants to keep this loom will give her an idea of what size to order next time!

Gone

Thanks,

Ahhh, the round bar! I have the same bars on my Tools of the Trade - and Texsolv, and a similar issue with the heddles being tight, but there are j-hooks I can unclip the bars from and they loosen up to move around.

I'm with White Sofa Dog too! Wire heddles are easier, but now that I've put the texsolv on the loom, I want to try them. I've only ever used wire.

Submitted by Coraeick on