Have had some time to look at the set up on my loom. Have untangelled a few tangles but still not getting a large enough shed for the shuttle. Have put what photos I think might be relevant on flickr. ( http://www.flickr.com/photos/7866840@N07/ ) Photos are of everything I thought might be relevant. MAny Thanks in advance Paul

Comments

ReedGuy

Paul, you should read up a little on Joanne's postings here and her website on tie up of a counter balance. You may be having troubles due to the middle cords not having a long enough "Y", your treadles may not be tied up high enough for the range of motion between opposing shafts (some up, some down), your lamms may not be level or slightly upward enough to clear the treadles. It appears the shafts are not tied up even and level, one side is higher than the other. In photo 1434 one balance yoke is canted and the opposite one has not moved. This is not tied up properly.

Joanne Hall

Hi Paul,

You need to have someone push down on the treadle when you take the photo.  There is usually no shed when you are not treadling.  I did not see shaft holders.  If the shaft holders are holding the shafts in place, then we can evaluate the tie-up of the horses.  Below is the link.  Parts 1 and 2 will be helpful.  In general it looks fine.  If the treadles hit the floor before the shed is fully open, then you will not get a big shed.  If you don't have lamms, you need the help from the second file.  The elastic bands will help with keeping the heddle bars in place.  And you need to tighten the tension and weave an inch or two and then make the adjustments.

Joanne

http://glimakrausa.com/learning-looms-weaving/intro-to-countermarch-and…

steve104c (not verified)

Just a suggestion. Looks to me the heddles are too short. Put on longer heddles and you should get a wider shed. What are the lengths of the heddles you have on your loom now?  Joanne Hall  can get you Texsolve heddles 10 1/2 " - 11"  long which should give you about 4"-4 1/2" shed ( depending on the width size of your reed)..............Steve.
Submitted by paulz on