So I use teh Haley Studio calculator (BTW thanks) So I was wondering when it comes to loom waste. It appears that the average 20-30 is maybe for a large floor loom but what about the tabletop leclerc and the dorset. whats the average for those looms that I should put into the calculator? thanks Becky

Comments

Sara von Tresckow

Loom waste is individual to each loom.

Surprisingly some table looms have more than you'd think and some floor looms have very little.

When acquiring a new loom, measure carefully on the first warp how much extra you need.

loomyladi (not verified)

When I warp a loom for the first time I like to measure from the back beam to the heddles and double the number, using that for loom waste.  After finishing the project you can do an actual measurement. 

sally orgren

Not sure about the Dorset, but for the Voyager and Dorothy with the "normal" (not extended) castles, I typically have 3-5" at front, and 7-12" at the back.

When tying onto the front, I group my warp into small 1/2" bouts, tie overhand knots within an inch of the end of each bout, and lash the knots to the front beam. My knots are usually pretty even, even after tensioning, and I don't weave much of a header, maybe an inch at most.

At the back of the loom, I slip the loop from the warp peg right over the rod that gets lashed to the back beam. So that rod can go right up to the back of my castle as long as the lashing cord is long enough. On an 8 shaft Voyager, the castle is less wide than on my 12 shaft. Also, if I am only using the first four shafts of either loom, that allows the bar to get close to the castle without the warps constricting the shed as much as if it were fully loaded. Those details account for the difference of 7-12"

Like Sara said, the best way to do this is measure your own project, on your own loom, with your preferred warping method. I keep a little project notebook with the current heddle count for each loom and the loom waste.

sequel (not verified)

Almost any loom warped un-sectionally can be tweaked for less loom waste by mounting an additional rod from the aprons forward.  Just tie or lash the additional length needed from the apron bar to the additional bar.  I've even done this with the warp on the loom when the back apron strings/tapes were too short.

debmcclintock

I've marked my looms with each one's actual loom waste for reference. When I am dong my warp calc and decide which loom I'll use I double check the loom label to make sure I use the proper length for that loom's waste.
Submitted by Anonymous (not verified) on