Hi all, 

I recently bought a used 24" Harrisville floor loom and I needed to replace the cords holding up the harnesses. While doing this I tried to mimic the way I undid them but I might have tied them too tightly or I didn't tie them in the correct directions and I am looking for assistance in tying harnesses and connecting each one to their corresponding treadle.

I have included pictures of the problem and am looking for some help/ guidance. 

Let me know I can provide anymore information and thank you in advance for the help!!

 

Best, 

Effie

Comments

danteen (not verified)

I'm not sure from the pictures, but it looks as though you should have the loop  on the black cord down below  in the wrong place to start.  Put it on the hook on the top of the shafts.  Then go straight up to the pulley from the inside and around it to the outside of the loom.

On the left side this would be counter clockwise.  

Then go straight down to the s-hooks connected to the lower cords that are under the shafts.

If you contact Harrisville, could they send you a picture?

Teena Tuenge

Submitted by schmeffie on