I

 

I just bought a portable Dorset loom that me and my husband went to get in New Jersey.

It is in very good condition but the needles are looses so not on the 4 shaft.

To top it of, they are flat needle and there sim to be a left and right side to the eye of the needle.

They are 8.5 inch from top to top of the eyes. the total lenght is 9 inch.

 

Does some one can hepl me on how to set up my needles on the shafts ?

And does some one know were I could by some needles for that loom, I presently have about 1000 needles but I would prefer having regular needles not flat.

 

 

Thank you.

Comments

mrdubyah (not verified)

Mimus - Disconnect one end of the crossbars on each frame and slide the heddles on at the top and bottom.  Turn the heddle so the center hole faces the front and back of the loom (so you can see through it).  Put as many heddles on the frame as you will need for your project.  Then, reattach the crossbars on the frames. There is nothing wrong with your steel heddles but if you prefer you can purchase inserted eye heddles or texsolv heddles at http://www.mielkesfarm.com/heddles.htm. 

Michael White

Mimus,

Hi, Got you email. I am glad I was able to point you in the right direction to find a loom.  It took me a min. to figure out that you are writing about HEDDLES. The best way to get your flat heddles on the heddle bars is to turn them all so they are in the same direction. Run a piece of yarn through the top and bottom holes. (anytime you remove the heddles they should be tied up)Remove the heddle bars and run them through the holes in the heddles, then reattach the bars to the heddle frames.

Leclerc sells wire heddles through it's dealers. To get the size, measure the heddle bars outside to outside. I will try and find information on Dorset looms for you. The 9" heddles you show is tip to tip, that is not the size you want. 8 1/2" I guess is the right size. 

Did you have a nice trip from Canada to NJ?

Have fun weaving,
Michael

 

 

steve104c (not verified)

Minus, You might want to replace your metal heddles with Texsolv heddles. Quiet and will not wear on you warp threads. Just an idea. Call Glimakra USA @ 1-866-890-7314 and tell Joanne what size your heddles are and she will be able to help you..........Steve.

Mimus (not verified)

Very nice trip in the USA but very very hot 106 f.+ humidity.

Your right it is 8.5 inches.

 

Mimus (not verified)

Thank you for the phone number ,I will call tomorow .

debmcclintock

you can get their phone # from here

for future system reference if a link doesn't work just start backspacing on the address in your web browser address bar and you'll hit the proper link.  sometimes things don't cut and paste properly....this link worked once you backspaced to  http://www.mielkesfarm.com/

Mimus (not verified)

Thank you to let me know how excuse my spelling I'm french.

debmcclintock

no worries, someone showed me how in to do this in my electronic past, I can assure you I did not figure it out on my own 

AND your English is Way better than my French!  Deb Mc

Submitted by Anonymous (not verified) on